Search Documents

To enable AN-FO .tòo' be used on an equal .weight basis wish Nitro Gl reerin.e expl3oòsives r smaller diameter bore holes became necessary With consequent modifications to drill steel and burden on holes, De't'onation of AN-FO "in small diameter holes proved successful' both with 'and without primer charges but some altorat-ions were required to. adopt Anolodeòr.s to the smaller -holes, Important factors in training all operators In the new charging method were the retention of imp-,cved, fragmentat'ion, avoidance of excel ive ove:break and keeping wall rock dilution 'to an absoluato mi. iArurle ò The ò successful storage of Ammonium 14t-rate in c"!ime.tic conditions 'with daily'.-' temperature fluctuationc above and below the critical' 90¦F, has. been "achieved,

Jan 1, 1964

The design of water and ore addition points has an important bearing on the ease of operation of a grinding circuit. The nature of some of the design decisions and the possible options of the designer are discussed. For example, design decisions determine the ease of alteration and measurement of flowrate, the ease of maintenance, and the effectiveness of feed- back control loops which maintain material inputs (water and ore) at required values. To illustrate discussion in the paper, a grinding circuit which contains one rod mill and one ball mill in series is used. Practical ramifications of desigl decisions :;ne stressed.

Jan 1, 1978

By Fuerstenau DW

The flotation of pyrite in ethyl xanthate solutions is presented along with electrokinetic results. The results have been analysed in view of recently published thermodynamic calculations as well as other published data on the pyrite-xanthate system including adsorption and voltarnmetry studies. The flotation response of pyrite in xanthate solutions is characterised by two maxima, one at pH 4 and the other at pH 8-9. The acidic maxima is also associated with a reversal in the electrophoretic mobility of pyrite, probably due to the formation of ferric xanthate on the pyrite surface through chemisorption of xanthate ions while the basic maxima is not associated with major changes in the mobility and flotation at this pH can probably be attributed the adsorption of dixanthogen. It is concluded that there is not sufficient experimental evidence to conclusively attribute the lack of flotation response in solutions at near neutral pH to any particular phenomena, either kinetic or thermodynamic.

Jan 1, 1993

Companies involved in the mining industry are exposed to risks, referred to as corporate risks, as part of the business process. Directors and management should be aware of these risks and make appropriate business decisions to address each risk. If business risks are not addressed on a timely basis the consequences are likely to be serious and will adversely impact the ultimate success of the business.The key corporate risks are:Poor cash flow and treasury management. ò Incompetent or unmotivated staff.ò Poor product quality.ò Accounting systems that do not provide meaningful and timely information.ò Computer system deficiencies. ò Ineffective credit screening.ò Assets not adequately protected.ò New ventures undertaken that are either inappropriate or not adequately researched.Exposures to corporate risk should be dealt with by Directors and management by systematically identifying major risk areas and implementing appropriate internal and management controls to deal with such risk areas. Proper management controls and procedures include the setting of overall corporate objectives and policy, monitoring adherence to such policy, establishing early warning systems to highlight problem areas and maintaining security over assets.

Jan 1, 1990

An intensely sheared and mineralisedIzone occurs in the Quartz Dolerite Greenstone (or Younger Greenstone) mass on, the western limb of the Kalgoorlie Syncline. This zone comprises the western part of the Golden Mile and has produced the greater part of the 33,000,000 ounces of gold produced to date from the main mining belts. A study of.th e general geological and structural features gives rise to the expectation that the lode shear system,will continue southward on a pitch similar to that of the maln syncline whose axial plane may be referred to as the "Boulder Dyke". Although payable ore has recently been found further south than previously, the expectation of large quantities extending southward from the present mining areas is Problematical.'

Jan 1, 1964

This paper deals with the evolution of present mechanised declining and orebody development practices at Kambalda, since their inception in 1969. Eight separate decline accesses have been established over the past eighteen years and to date some 175 kilometres of declining and lateral development has been achieved utilizing a wide range of mechanised development and mucking units. Improvements in-the range of equipment available, functionalization of the develop- ment tasks and the resultant changes to piecework contract structuring have all contributed to the improved performances achieved in this concept of mine development. Even though numerous development advance rate records have been established at Kambalda, an ongoing evaluation of changes to both drilling and mucking units is underway to further improve these development performance rates.

Jan 1, 1987

By G T. Hefter, P Singh

Sulphur dioxide oxidation is an attractive alternative anodic reaction to the evolution of oxygen in copper electrowinning. Accordingly, the electrochemical oxidation of SO2 in aqueous 1.0 x 10-1 mol/L NaClO4 has been studied at pH 2.3 using platinum and glassy carbon electrodes. On the platinum electrode SO2 oxidation occurred on the forward scan at 0.96 V and on the reverse scan at 0.63 V. For GC, a single SO2 oxidation peak occurred at 1.40 V on the forward scan. SO2 oxidation on both electrode substrates was hampered by oxide layer formation. The electrode could be reactivated however, by oxide layer reduction. Although reactivation was most successful for platinum, SO2 oxidation on platinum is quite complex, with this evidenced by the reverse scan anodic peak. Glassy carbon shows simpler behaviour and thus, is the preferred substrate for SO2 oxidation.

Jan 1, 1998

By Turner R. B

The authors have studied and analysed many mineral resource and related projects in Australia. These studies have lead them to conclude that the past performance of many project developers does play a major part in any external financial investment for new or expanding resource based projects. In this paper the authors look particularly at the influence of parties outside the direct control of developers and the effect of-these parties on projects and conclude with a number of points as guidelines for potential project developers. This paper represents the view of the authors only and should not be taken as a representation of the views of the Australian Resources Development Bank Limited.

Jan 1, 1980

Due to collapsing copper prices during 1974/75, a rapid changeover was made at the C.S.A. mine from mechanised cut and fill stoping with incline access to the more economic long hole open stoping method. In 1974/75, 20 per cent of total production came from open stopes. For the 1976/77 year-to- date, more than 80 per cent of total production has been won from open stopes. As a result, mining performance has improved considerably. Stops, drilling performance has increased by more than 50 per cent since the changeover from extension rod, 50 mm diameter cut and fill uphole drilling to 115 mm diameter in-the-hole hammer drilling of holes up to 65 m long. Stops blasting performance has improved from 750 tonnes to 950 tonnes blasted per manshift. Open stope primary blasting per- formance is much higher, but reduces to 950 tonnes per manshift when secondary blasting and firing of hung drawpoints are taken into consideration. Ground control, the most expensive and least productive aspect of cut and fill mining, is almost entirely eliminated in long hole open stoping.

Jan 1, 1977

By Simes C. D

Results of experiments for dissolution of zinc by aeration of sphalerite in glass, copper, galvanised iron and stainless steel vessels of identical dimensions are reported. It was found that in a glass container dissolution of zinc reaches a maximum after 30 min aeration and then decreases whereas in the copper container dissolution remains nearly unchanged up to 30 min aeration and then increases. In the cases of galvanised iron and stainless steel containers zinc dissolution increased steadily with time up to 60 min aeration. It is suggested that the different rates of dissolution in glass and copper containers may be due to electro-chemical actions.

Jan 1, 1984

By Hosking JW, Muir DM, Ruane M, Smith I. Hinchliffe WD

Maintaining carbon activity is critical to the satisfactory recovery of gold in the Carbon-in-Pulp (C.I.P.) process. Reduced activity can lead to gold losses in tails and lower tonnage throughput.Carbons from a number of W.A. C.I.P. circuits have been examined for the extent of fouling by inorganics such as calcium, magnesium, copper, nickel and silicon. Many of these carbons have exceedingly low activity leadingto low gold loading and excessive contact times. The relative importance of these fouling agents and cyanide levels on carbon activity is discussed. Mathematical modelling shows that relatively small improvements in kineticactivity lead to much lower tank volume require-ments and carbon residence times.

Jan 1, 1984

North Stradbroke Island is a large sand mass offshore from south east Queensland. Dredging for mineral sands commenced there in 1956 and the rehabilitation discussed in this paper was commenced in 1967. The frontal dunes have a long history of instability, with little vegetation prior to mining. Re-establishment of the naturally stable contours is essential, and their rehab- ilitation is described. Vegetated high dunes present different problems requiring attention to regeneration of the native species. Methods developed over the past eight years are proving successful.,

Jan 1, 1976

Owing to the 'creeps' and consequent movements in the mines, followed by the recent fire in the southern workings, the whole of the orebody above the 800 ft. level is now very much crushed and broken. The same applies to the hanging wall or overwall coutrny, which has subsided towards the workings, so that for some years past all development work within the lode has had to be carried out with extreme care.The continual but slow subsidence of the overburden into the stopes necessitates a periodical renewal of all gangways in the lode, and, as the subsidence amounts to as much as 60 ft. in places, these new gangways must necessarily pass through the mullock-filling of old stopes in addition to broken ore. They at times pass into the broken ground of the hanging-wall for some distance, where the orebody has widened underneath by the original folding and puckering.

Jan 1, 1932

The results of iron ore exploration in Western Australia between '1961 and 1964 are outlined, with particular.reference to the Hamersley Iron Province. Exploration during: these three years has increased the known resources of the-,Statle from 275 million tons to almost 9,000 million tons of high- grade hematite ore. In addition, reserves of lower-grade .pisolitic limonite ore are-estimated to amount to 6,000 million tons. The origin and characteristics of the different types of ore is discussed,

Jan 1, 1964

By Conley R, Payne I

The Vickery Coal Mine commenced open cut mining operations in May 1991. All overburden and interburden is drilled and blasted for excavation by dragline or hydraulic excavator. The mode of operation adopted from the feasibility studies requires that throw blasting of the overburden be used to assist dragline productivity.This paper reviews the development of the drilling and blasting practices with particular emphasis on the throw blasting of the overburden and optimisation of costs. This review includes analysis of the pre-production drilling and blasting feasibility studies by comparison with actual results.

Jan 1, 1992

Increasingly, mineral operations need to manage water as a key business asset. Managing water solely as an environmental issue leaves a business exposed to social, cultural and economic risks associated with water. Adopting a company-wide strategic approach, which takes account of the true value of water will provide businesses with opportunities and risk protection. Rio Tinto has recognised the business imperative for water stewardship and has responded by producing the Rio Tinto Water Strategy. This strategy commits the company to managing water assets in a responsible manner, taking account of environmental, social and economic values. To incorporate the true value of water in site decision making, a new set of tools is required at the operational level. A key part of the strategy focuses on developing a framework to value water based on case study examples from around the Group. This paper presents progress on the companyÆs experiences in developing and implementing the water strategy.

Jan 1, 2006

Government geoscience may be categorised by objective under three headings: Applied Research for Geoscientific Framework Studies, Resource Inventory, and Technical Advice. In Queensland, the Department of Resource Industries is active in all three categories. Under the program-based management system adopted in 1987, three Programs, namely, Geological Survey, Mineral Resources Development, and Energy Resources Development and Utilisation, have geoscience responsibilities.Prime responsibility for geoscience resides with the Geological Survey Program, which provides a geoscientific framework for mineral and energy exploration and the development of the State. Simply stated, the Program goal is to provide geological information when and where it is required. Geological Survey work also encompasses aspects of resource inventory and technical advice, complementing the work of the other two Programs. This role has a 122 year long tradition, for geoscientists of the Geological Survey have been engaged in investigations designed to facilitate the identification and utilisation of the mineral, water and energy resources of Queensland since 1868.

Jan 1, 1990

By Restarick CJ

A compound cylinder-cyclone system, fitted with a flow control valve between the cylinder and cyclone, has been used for coal slurry sizing experiments in the range approximately 100 to 300 micrometres. An important feature of the system is the ability to adjust the cut size of the separation over wide limits by adjustment of the flow control valve. Results have been compared with typical fine screening operations. Under roughly equivalent conditions the compound cyclone system can achieve better elimination of extreme fines, but is not as sharp as the screen for coarser size cut-off. Simulations of systems involving combinations of the cylinder-cyclone system with screens indicate that the advantages of both sizing devices can be combined to yield accurately sized products for fine coal cleaning, at much less cost than using screens alone.

Jan 1, 1984

There are two main areas of application of geology in quarrying: (i) In regional planning for industrial mineral requirements.(ii) In direct quarry management. The regional planning requirement has recently become more evident because of greatly increased land demand conflicts around cities. The direct quarry involvement is a reflection of both the economy and the greatly increased sophistication of the quarry industry. Here, professional planning and development expertise by a geologist is required, to ensure continued supply of raw materials at the best price to the consumer with sufficient profit to the producer. Today, geological insurance safeguards capital investment in plant and assures economical development plans.

Jan 1, 1978

By Sillet R, Corin P. J, Wilson G

Zinc Corporation of Broken Hi11 had some long hole stopes coming into use which could not be mined using diesel loaders, because of ventilation restrictions. In preference to use of pneumatic loaders, and because there were no field proven electric loaders in Australia, Horwood Bagshaw Ltd., were commissioned to repower a diesel loader with an electric motor, within the confines of the existing machine

Jan 1, 1977