Search Documents

By Maru Y

The use of mercury for amalgamation has been an integral part of the small-scale gold mining industry in developing countries owing to its low investment cost, simplicity of the technique and high gold recovery. However, its impact on health and environmental hazards have not been given the attention they deserve. In spite of the growing awareness and concerns over the mercury pollution problem by regul-atory authorities, precautionary measures such as bans on the use of mercury in some countries have been largely ineffective.This paper first reviews some of the mechanisms of mercury poll-ution, and mercury toxicity which varies according to its oxidation state. It then describes how mercury released to the atmosphere would go through the "Mercury Cycle". Compar-isons have also been made with previously measured mercury levels in small scale Papua New Guinean miners with their counterparts in other developing countries.

Jan 1, 1994

By Floyd JM

Conventional smelting reactor systems were designed to recover only one main element from their feedstocks. They did not possess sufficient flexibility to allow optimisation of co-production of multiple values from a complex feed.New reactors such as Sirosmelt and Top Blown Rotary Converters are providing new possibilities for making separation between components and this is of great significance for the complex feeds which are becoming prevalent in the metal extraction industry.Process routes using chemical procedures which take advantage of the flexibility of these reactors will be discussed in relation to a number of possible feedstocks.

Jan 1, 1985

By Hughson B

The need to prevent the sterilisation of coal stems directly from the fact that it is a non-renewable resource. In N.S.W. a vast amount of coal resource is located under major public utilities such as freeways, railways, stored waters, pipelines carrying gas, water and sewage, and transmission lines. Total extraction has occurred under freeways, transmission lines and pipelines with little or no damage. Where damage has resulted, the cost of restoration was only a small fraction of the value of the coal recovered. However, coal at present is being sterilised and perhaps lost for ever under stored waters and railways. If engineering solutions are available for mining under these improvements economically and with maximum safety, then coal should be extracted and utilised to the benefit of the State.

Jan 1, 1986

The Australian Centre for Minesite Rehabilitation Research (ACMRR) was established through a mining industry initiative to meet the need of industry, governments and the community for sustainable systems for land affected by exploration, mining and mineral processing activities. The Centre, which is a consortium of the major groups associated with mining rehabilitation research in Australia, has a focus on both strategic research and technology transfer and combines a wide range of multidisciplinary skills covering engineering and the physical and biological sciences. The paper briefly describes the goals, structure, expertise and research and technology transfer activities of the Centre. The major research program areas of waste rock dump and final void stability, acid mine drainage, tailings disposal, and remediation of ecosystem reconstruction are described in the context of national Priorities.

Jan 1, 1995

By A Mulyadi, J Barber, R Golden

The Deep Ore Zone (DOZ) underground mine will be a 25 000 tpd mechanised block cave operation starting production in 2000. The ore handling system consists of a direct truck dumping 54 +74 gyratory crusher, which feeds into an ore bin. An apron feeder below the bin is used to load a conveyor belt. This paper describes the design, sequencing and methodology of the crusher station, ore bin and feeder chamber excavations. The Geotechnical investigation and analysis of the site are also discussed as well as the design, installation and quality control of the long-term ground support methods.

Jan 1, 2000

The energy crisis and the general increase in fuel prices have changed the position of coal in the world. Countries need to review their policies on coal, depending on available reserves and their accessibility. On the demand side, a distinction should be made between the steel industry's specific demand for coking coal and the needs of power stations where coal is used in competition with other sources of energy. Coal consumption in these two sectors is expected to increase considerably over the foreseable future. Some countries have sufficient coal of their own to meet this increased demand but others will have to rely on imports. As a result, the tonnage of coal transported by sea may double by 1985. The coal industry lacks flexibility. The opening of new mines and the construction of a transport system to ship the coal takes time. This time-lag, coupled with the enormous expenditure involved, makes long-term contracts between producers and consumers essential.

Jan 1, 1975

By Lawrence PR, Hoffman W

The dissolution of gold from various ore-bodies is discussed in terms of extraction rates and reagent consumptions during leaching. Gold dissolves slowly in cyanide but reagent consumptions are usually satisfactory. In almost all cases where excessive cyanide consumptions occur, similar high consumptions result with other lixiviants. Recovery of gold from cyanide solution is well established and comparatively simple technology.Gold dissolution in thiourea is faster than cyanide but significant consumptions of thiourea, due to both adsorption and oxidation, occur. Gold recovery from thiourea solutions is likely to be more difficult than from cyanide.Chlorination of gold is very fast in acidic conditions but excessive consumption of chlorine occurs for ores containing greater than 0.5% S. Reprecipitation of gold and handling of acidic chlorine solutions are both significant problems. The mechanism of gold reduction onto activated carbon creates difficulties in the carbon in pulp process for recovery of gold but means a simplification in the production of bullion from loaded carbon.

Jan 1, 1984

Having successfully applied computer techniques to open pit mining applications, many software developers are now using their skills to tackle the much harder areas of underground mine design, planning and production.Dramatic improvements in the performance to price ratio of hardware (including high resolution graphics screens), a better understanding of the techniques of surface and solids modelling (and their subsequent display), moves towards standard user interfaces and advanced concepts of representing grade distribution in the ore body have all contributed to the recent increase in underground mining software activity.This paper details the general requirements of a workable underground mining software system, providing a minimum checklist of desirable features and emphasises the importance of ease of use, flexibility and intuitive feel. Some relevant trends in hardware, software and application techniques are highlighted and comments made on areas which require further development or are only available in a small number of packages.Finally, a comment is made on the role of computer models to provide a unifying medium for tying together all aspects of underground design, planning and production.

Jan 1, 1992

An extensive railway construction prog- ram in the People's Republic of China has required the excavation of many tunnels in difficult ground, particularly in mountainous regions. Conclusions drawn from case histories permit guidelines to be formulated as to the optimum location of tunnel alignments in faulted and folded terrains, and also in karst regions. Geological factors adversely affecting durability of tunnel linings can be minimised by adoption of appropriate construc- tion practices.

Jan 1, 1987

The importance of orebody definition and optimisation in project development cannot be overstated. Inappropriate orebody definition is the single most important reason for project under performance and/or failure. Without the firm foundation of good orebody definition, the structure of a project cannot be assembled reliably. Many factors need to be considered in the process of orebody definition. These factors are well summed up in paragraph 123 of The Institute's Code and Guidelines for Assessment and Valuation of Mineral Assets and Mineral Securities (Valmin Code). The factors range from the initial geological data through assaying, geotechnical and hydrogeological factors to mining and metallurgical considerations. There are other factors which also need to be considered including marketing and environmental factors. This paper briefly reviews some of these factors and their impact on project development. Three examples are presented where one or more of these factors have had significant impact on the development of the Project.

Jan 1, 1997

By Croggon R

Passing a direct current through a jointed fine grained soft rock mass auses the movement of water by the process of electric-osmosis. There are other processes such as electrolysis which transport ions that interact with associated ions and can, in turn, be oxidised. This results in the dissolution products being transported towards the cathode electrode. In the cathode region the ferrous hydroxide is oxidised to ferric hydroxide %%ith consequent precipitation. The cracks and joints are current pathways, along which the ferric hydroxide is deposited. This deposition reinforces the joints and increases the shear strength. By adding calcium chloride to the anode, the rate of corrosion is increased with the concomitant increase of deposited ferric hydroxide along the joints. This, in turn, significantly increases the joint shear strength. The process is pervasive in that the current via the water paths travels through the crack and joint systems The result is that not only specific joints are reinforced but the cracks and mtciconnected voids are also reinforced.

Jan 1, 1997

An intensely sheared and mineralisedIzone occurs in the Quartz Dolerite Greenstone (or Younger Greenstone) mass on, the western limb of the Kalgoorlie Syncline. This zone comprises the western part of the Golden Mile and has produced the greater part of the 33,000,000 ounces of gold produced to date from the main mining belts. A study of.th e general geological and structural features gives rise to the expectation that the lode shear system,will continue southward on a pitch similar to that of the maln syncline whose axial plane may be referred to as the "Boulder Dyke". Although payable ore has recently been found further south than previously, the expectation of large quantities extending southward from the present mining areas is Problematical.'

Jan 1, 1964

The Western Australian Mining and Petroleum Research Institute (WAMPRI) was established in 1981 by the Western Australian Government as a funding and co-ordinating Institute to foster research into the mining and petroleum industry within this State. To June 1984, the Institute has sponsored 34 projects with a total notional value of $2.5 million and an actual cash commitment of $1.5 million. Strong support for WAMPRI has come from Industry with 60 companies contributing half the money needed for the research grants.The 34 WAMPRI projects funded so far cover all aspects of the mining and petroleum geosciences.Several WAMPRI projects are concerned with gold including processing technology and the development of exploration models and techniques, they are providing successful results.Although well supported by Industry there is a surprising lack of applications being submitted to the Institute in the area of mining engineering, where it is felt there is much scope for research projects.

Jan 1, 1984

A major problem with many items of underground equipment is that they have either been converted or adapted from surface equipment, or that they have been designed and assembled in comfortable offices and factories with adequate lighting, specialised tools, and ample space. As soon as they are in use underground in cramped spaces maintenance frequently becomes difficult, parts are awkward to change, and a whole range of accidents can happen.Similarly, ingenious operators discover a whole range of uses for which the equipment was not designed, such as using a loader bucket for a work platform, or scaling backs with it.Design modifications of equipment and removal of hazardous components that can trap limbs is expensive when the dangers are discovered in operation, sometimes posthumously, and it is not surprising that workers compensation insurance premiums are high. The cheapest place to ensure that equipment is safe is in the design office, where the operator should be considered first, rather than being added to a purpose built machine as an afterthought.

Jan 1, 1992

By D Manhire, G Hogan, M Ryan, S Whiteley

Site restoration at the L&M Mining Limited alluvial gold mining project at Waikaka near Gore, Southland is described. In 2000 mining operations started to recover alluvial gold beneath historical dredge tailings over 244 hectares in the flood plain of the Waikaka Stream. The project had an eight to nine year mine life but was prematurely closed in 2002 because of economic considerations. Restoration of the site back to pastoral farming, with shelter-belt and amenity tree, shrub, and wetland plantings is described. Dealings with the landowners and regulating authorities are addressed in the paper.

Jan 1, 2003

Bougainville Copper Limited (BCL) ships about 600,000 dry tonnes of copper concentrate per annum to Japan, Germany and Spain, with some spot sales to other countries. Concentrate sales value for 1984 was 335 million US$, representing almost half of PNG exports. Contained metal determination is based on physical and chemical measurements on representative samples. The entire procedure is subject to statistical uncertainties and possible systematic errors; losses as high as several percent of contained copper or gold are common and frequently are regarded as unavoidable. In this context, the function of the chemical laboratory is to identify and eliminate such errors and recommend correct technical procedures for possible inclusion in sales contracts. BCL's marketing management has encouraged this approach and the close buyer versus seller agreement is beneficial for all parties involved. BCL participates in the respective technical committees of the Standards Association of Australia (SAA) and the International Standards Organisation (ISO). Standard methods for sampling and analysis of copper, lead and zinc ores and concentrates are in course of preparation, some being due for publication shortly.

Jan 1, 1986

By Trevits MA

The United States Steel Corp. in cooperation with the United States Government is conducting a large-scale methane drainage field demonstration using stimulated vertical boreholes drilled in advance of mining. A grid pattern of 23 boreholes, isolating approximately 1.5 km2 of coalbed area, has been drilled to the lower bench of the Mary Lee coalbed, Jefferson County, Alabama. Upon completion of drilling operations, various hydraulic stimulation treatments utilizing nitrogen-generated foam, water, and gelled fluid were performed to enhance the rate of methane gas removal. Production from the grid pattern began in September 1977 and continued as the last borehole was placed on production during October 1980. To date, in excess of 33,800,000 m3 of methane gas has been drained as a result of this effort. Underground mining operations were approximately 3.2 km from the grid pattern when production began and have currently progressed to within 1.6 km. Underground interception of the grid is expected in 1986.

Jan 1, 1982

By Towsey C. A

Significant advances in regional geochemical exploration techniques have been made over the last 5 years in the search for gold deposits. This has occurred largely by the development of the bulk cyanide ex- tractable gold (BLEG) also known as the Bulk Cyanide Leach (BCL) tech- nique. The technique has been developed and designed for Australian conditions and has two main ad- vantages over the pan concentrate technique preferred by many ex- plorationalists, viz:,. 1. It is designed to collect ultra fine gold common to epithermal and other north Queensland types of gold deposits. 2. The large sample (approx.5 kg) allows very low detection levels, ranging between 0.1 and 0.05 ppb Au. The use of the BLEG technique in exploration has led to the discovery of the Wirralie gold deposit and numerous other epithermal gold prospects previously undetected by pan concentrate and minus 80 mesh (pathfinder elements) surveys in the Drummond Basin.

Jan 1, 1989

By Conley R, Payne I

The Vickery Coal Mine commenced open cut mining operations in May 1991. All overburden and interburden is drilled and blasted for excavation by dragline or hydraulic excavator. The mode of operation adopted from the feasibility studies requires that throw blasting of the overburden be used to assist dragline productivity.This paper reviews the development of the drilling and blasting practices with particular emphasis on the throw blasting of the overburden and optimisation of costs. This review includes analysis of the pre-production drilling and blasting feasibility studies by comparison with actual results.

Jan 1, 1992

1991 New Zealand Branch Annual Conference û Appendix

Jan 1, 1991