Search Documents

By Hutchinson H

Froth flotation is applied to mineral sand concentrates in order to produce commercially viable xenotime concentrates. Experiments indicate that a xenotime product containing 38% Y203 at 47% recovery or 34% Y203 at 83% recovery can be obtained from a 27% Y203 feed. The process involves a primary stage of reverse flotation at which oxide and silicate gangue is floated, and secondary stage of direct flotation at which xenotime is floated. Of the various collectors screened an amphoteric compound was found to be effective at both stages. This was made possible by the addition of sodium silicate at the second stage, which acted as depressant for the remainder of the gangue. Similar studies on a low grade feed material were somewhat unsatisfactory as the grade achieved fell short of what was targeted.

Jan 1, 1990

The published safety policy of Mount Isa Mines Limited, together with details of the organisation and control techniques adopted by management to pursue an active safety programme within the company, is presented. The importance of communication by management through the organisational hierarchy and procedures instituted to ensure rapid and concise feedback on safety concerns are detailed. The paper also describes the role of the occupational health department and safety committees in assisting management to monitor the safety effort of supervisors and employees. Current safety performance levels are tabled together with details of some aspects of the programme on which safety effort will be concentrated in the future.

Jan 1, 1975

Of the energy resources present in Australia, coal and uranium are by far the largest. These two resources ap- pear sufficient to satisfy Australia's energy needs beyond the immediately foreseeable future and long after the natural petroleum resources are exhausted or have ceased to play a significant role. By that time, coal could be converted in plants of very large size to synthetic liquid and gaseous fuels which will be used as substitutes for pet- roleum fuels, particularly for transport. The basic role of uranium will be to supply electricity from nuclear power stations for heat and power requirements, thereby freeing non-coking coal largely for conversion purposes. The establishment of these enterprises will require a massive national effort and a high degree of co-ordination at the planning stage.

Jan 1, 1975

The sucessful use of sewage sludge in land rehabilitation has been established and there is an abundance of overseas information on sludge reuse. Unfortunately Australia is behind Europe and North America in establishing sludge reuse policies and regulations. In Victoria the EPA has no publicised regulations and no communicated policy for sludge reuse. In the absence of sound regulations the onus is firmly on the operators of sewage treatment works to ensure land application of sludge is safe for the environment.

Jan 1, 1992

The necessity for agreed project outcomes, which are in accordance with client needs, and the subsequent requirement for a unique approach to managing project implementation is discussed. Reasons for appointing a separate project team to manage a project are established. The selection of a project manager, based on the services they can provide and on their characteristics, skills and management style, is discussed. The consequences of selecting the wrong project manager are explored. A broad overview of the requirements for the project team is provided. Criteria for the selection of team members, and the role played by the project manager in this selection, are discussed. The levers that drive `on-time and on-budget' projects are discussed in terms of the project's vision, goals, controls, and incentives.

Jan 1, 1997

By Grainger A, Dawkins G, Lysaght A, Kennedy R

Maintenance management improvement projects were undertaken at several BHP Collieries Division mines pursuing.the objective of achieving better structured maintenance procedures. Efficiently structured maintenance and optimum asset use are interdependent and productivity and computer models assist towards that objective. Definition of aspects of maintenance and analysis of the nature of equipment and materials, workloads and tasks, lead to more effective planning and scheduling of maintenance. The quality, standards and procedures of records must be suitable and adequate for storage and future retrieval. Total Quality Control initiatives and improvement projects even extend into spheres of customer/supplier relationships and problem solving teams as well as the more recognisable standards of management and performance factors in maintenance. All such factors contribute to a Maintenance Management Matrix to provide a better structured approach to economic maintenance management in the capital intensive coal mining industry.

Jan 1, 1991

Aberfoyle sought to reduce Hellyer project development risk to a greater degree than usual. Consequently the ore reserves estimate and feasibility study were particularly comprehensive. A detailed ore reserve study was completed based on extensive drill core and underground sampling, large scale pilot plant work and a detailed feasibility study. Leading external consultants were used for advice on commercial matters which impact on ore reserves and to audit major technical conclusions, including the results from pilot plant work and the ore reserve estimate. Other project risks were diminished by negotiating a State agreement covering security of title, royalty formula and environmental management procedures, by obtaining sales contracts, and by analysing Hellyer's position on an industry cost curve. The task of financing the project was much simplified by the extent and quality of information available from the ore reserves estimate and feasibility study report.

Jan 1, 1990

By Watkins JR

The educational system is a dynamic; a flow resource that can be significantly shaped, changed and - refined by educationists. This paper analyses these various facets of geo- science education in Australia. The Australian educational philosophy is essentially a laissez- faire model, a free market approach without any real government or professional directive or stratagem. Students are therefore free to choose their own educational pathway dependent only upon their ability and the access to courses. Geological education at the tertiary level in Australia is described and critically analysed. There is a real need for a rationalisation of geological education in Australia, and this rationalisation should include not only the number of courses offered but should also aim to fully define both the philosophy and purpose of geological education and the accreditation procedures for the Students.

Jan 1, 1986

In China the hydrogeological type of solid mineral deposits can be divided into A. Mineral deposits with fissure water; B. Mineral deposits with pore water; and C. Mineral deposits with karst water. The hydrogeological conditions of mineral deposits with fissure water are relatively simple with the exception of a few cases. Mineral deposits with pore water are few but great amounts of ground water can be encountered in the mine accompanied by floating sand or slope failure during the exploitation. Mineral deposits with karst water are complex in their hydrogeological conditions. Enormous inrushes occur frequently in the mines of north China; Karst collapses are a serious matter in the mines of the south; Subterranean river and conduit systems are often encountered in the southwest. This paper will give full discussion on these features and put forward a way of combating and controlling the groundwater problem in accordance with type and feature.

Jan 1, 1988

Currently there are in excess of 200 companies listed on the New Zealand Stock Exchange and the total market value of all the listed shares amounts to $4.6 billion. The number of listed mining companies stands at nine and with a market value of $35 million accounts for less than one per cent of the total market capitalisation. In comparison, the Australian mining and energy sectors account for nearly 50 per cent of the total market capitalisation, which currently exceeds A$41 billion. Surprisingly the share markets in both countries were primarily founded on the discoveries of minerals last century.

Jan 1, 1982

Silica and limestone fluxing levels in copper smelting slags were studied. Copper concentrates with flux additions were smelted to matte (55.5 per cent Cu) and slag in a pilot scale submerged combustion furnace.Results indicated that oxidic and sulphidic copper levels in slags were minimised with a slag Si02 level of 36 per cent and a SiO2/CaO ratio of 5.5. Total copper losses in slags were 0.6 per cent under these conditions.To produce the desired slag chemistry, additions of bulk silica and limestone to copper concentrates of fluctuating grades were predicted numerically. The method employed the solution of two simultaneous equations, each respectively for silica and limestone calculations.The predicted flux additions were applied in a further series of tests and the resultant stages were found to be satisfactory. The method is applicable to smelting 'operations which employ two flux bins, with weigh feeders, so that slag chemistry may be controlled with the flux/concentrate feed mix.

Jan 1, 1985

By Hughson B

The need to prevent the sterilisation of coal stems directly from the fact that it is a non-renewable resource. In N.S.W. a vast amount of coal resource is located under major public utilities such as freeways, railways, stored waters, pipelines carrying gas, water and sewage, and transmission lines. Total extraction has occurred under freeways, transmission lines and pipelines with little or no damage. Where damage has resulted, the cost of restoration was only a small fraction of the value of the coal recovered. However, coal at present is being sterilised and perhaps lost for ever under stored waters and railways. If engineering solutions are available for mining under these improvements economically and with maximum safety, then coal should be extracted and utilised to the benefit of the State.

Jan 1, 1986

The correct assessment and understanding of geotechnical conditions is fundamental to mine design and, hence, successful (safe and efficient) mine planning, design and operations. However, this assessment and understanding is simply not possible unless there is a sound appreciation of the geology of the project. This paper addresses geological uncertainty in mine engineering and its communication, and shows that a mining project that does not take geology properly into account in the engineering phase is fraught. Uncertainty levels become excessive, which leads to hazards and consequential risks in design and operations in terms of both safety and efficiency. Several examples, both positive and negative, are provided to make the point. The paper concludes that mining geologists must become more overtly cognisant of the influence of geology on mine engineering. Equally importantly, mining (and geotechnical) engineers must communicate better with their geological colleagues to ensure that they (the engineers) have a clear understating of the geological issues affecting their operations. The engineers must know how to ask the right questions of the geologists. Engineers who do not understand and take account of geology in their designs and operations are failing the expectations of stakeholders.

Jan 1, 2006

The Western Australian Mining and Petroleum Research Institute (WAMPRI) was established in 1981 by the Western Australian Government as a funding and co-ordinating Institute to foster research into the mining and petroleum industry within this State. To June 1984, the Institute has sponsored 34 projects with a total notional value of $2.5 million and an actual cash commitment of $1.5 million. Strong support for WAMPRI has come from Industry with 60 companies contributing half the money needed for the research grants.The 34 WAMPRI projects funded so far cover all aspects of the mining and petroleum geosciences.Several WAMPRI projects are concerned with gold including processing technology and the development of exploration models and techniques, they are providing successful results.Although well supported by Industry there is a surprising lack of applications being submitted to the Institute in the area of mining engineering, where it is felt there is much scope for research projects.

Jan 1, 1984

By Premur V

In industry and power production and distribution large quantities of fine wastes are produced. These are above all fly ash and phosphogypsum. Attempts are made to use them as secondary raw materials in industry and construction. Since they contain dangerous and harmful components or are nonhomogeneous their direct application is limited so that they are treated as waste. This paper reports on tests conducted with the aim of agglomerating the mentioned fine industrial wastes by pelletisation. The aim of this resarch was to obtain agglomerated product suitable for handling, transport and dumping. At the same time efforts were made to incapsulate harmful components by producing pellets with protective shells. Next, pellets without binders and with different binders were produced. Strength, resistance to freezing and solubility of pellets were tested. All the fine industrial wastes under survey were found to be suitable for pelletisation. The utilisation of appropriate binders ensures pellet strength required for safe handling and ecologically sound deposition of pelleted Material.

Jan 1, 1993

By Stubbs B

In conjunction with Charles Copeman, we have arranged the presentation of a paper by Charles with a support paper by myself presenting alternatives to currentaccepted legal concepts involving the ownership of minerals by the Crown and the absence of ownership in any minerals or entitlement to benefit therefrom by the owner of the land on or under which the minerals occur.2. The current situation has its historical route in the concept of gold and silver being royal metals and belonging wherever situated in the Kingdom to the King and it is submitted it can be'seen as being archaic in nature perhaps even feudal and perhaps worthy in this day and age of reconsideration.Our purpose in these papers is to present an alternative view supported by argument challenging the present system and hopefully, creating room for comment and interchange amongst those involved in the industry. My solutions are not Charles Copeman's solutions and vice-versa. However, we do share a common belief that the present system may not be the best system.

Jan 1, 1990

Uniaxial compressive strength and Young's modulus values measured in the laboratory on NX diamond drill cores were examined statistically to bring out any significant differences between different locations in the mine which might require special treatment in subsequent photoelastic analyses of the mine layout. Correlations were sought between the strength and modulus and various other features of the rock. The estimated mineral content of the core correlated with the modulus of the core, but the range of modulus values was too limited to show any strong correlation with compressive strength.Strength in the vertical direction was found to be significantly higher than in the horizontal direction and the same pattern was followed by the moduli, but was less pronounced. It was concluded that, whilst the modulus variations were significant, they would not invalidate any photoelastic studies.

Jan 1, 1969

By Mahony BK

This paper discusses the major infrastructure elements required to support a typical Australian mining development. Infrastructure elements are grouped into four major types, urban planning, transportation, power and communications and water supply. The design criteria applying to individual elements within these groups are briefly discussed as well as order of magnitude cost estimates. The use of simulation models to test the capacity of existing rail networks, as well as novel sources of energy generation, are also described.

Jan 1, 1983

This paper describes some experiences in the design of flotation reagent schemes for the efficient flotation of complex gold ores containing free gold and/or gold associated with easily flotable sulphide minerals such as chalcopyrite and bornite. Historically, the design of gold flotation reagent schemes has been based primarily on experiences using high dosage levels of water soluble charged collectors such as xanthates and dithiophosphates and carefully controlled regions of pH. This approach has been effective with gold associated with complex sulphide minerals, in particular gold associated with iron sulphides such as pyrite. An alternative two-stage reagent approach is presented that is applicable to certain types of gold ores. This approach involves using very small dosages of uncharged water insoluble collectors at natural ore pH followed by a modified bulk flotation reagent approach for the second stage. The reasons for utilising this approach, when applicable, are discussed and illustrated with examples.

Jan 1, 1997

During the post war era, the requirements of the "Third" World for modern civil works, energy and industry, coupled with an insistence that these capital installations are understood and controlled by indigenous people, have crea- ted a demand and flow of technology from those countries with well developed skills. Thus has grown a real trade in technology - an activity in which consultants play an important role. An indication of the magnitude of this trade is given, together with an outline of some of the special problems. Australia is shown to be dis- advantaged and has been slow to offer the incen- tives to consultants which other countries offer.

Jan 1, 1975