Search Documents

By Jimbo I, Ogawa O

A series of experiments was carried out to investigate the solubilities of copper, arsenic, antimony and bismuth in silica-saturated iron silicate slags under controlled oxygen partial pressures at 1200 and 1250¦C. Molten copper containing each of the above elements was kept in contact with a slag in a silica crucible for 24 or 48 hours to attain equilibrium. No me- chanical entrapment of metal into the slag was observed. The appearance of the magnetite phase in the slag was avoided by holding oxygen potentials at substantially lower values than that evaluated from available data on iron silicate slags. Solubilities of copper, arsenic, antimony and bismuth in slags were plotted against oxy- gen potentials and both oxidic and atomic types of dissolution were found, except in the case of arsenic, from the dependencies of the solubili- ties on the oxygen potential and from positive intercepts of regression lines when extra- polated to zero oxygen potential. The dissolu- tion of arsenic seemed mostly oxidic. Distri- bution coefficients of arseò,ic, antimony and bismuth between copper and slag are also Discussed.

Jan 1, 1980

By Dickerson A. W

The most important mining problem facing many of the established surface coal mines in the Bowen Basin area of Queensland is the rising cost of overburden stripping associated with increasing depths to coal. The Dragline-Hopper-Truck Project is one of a number of responses to this problem, and involves the design and construction of an experimental hopper followed by field evaluation of a dragline-hopper-truck mining system.Such systems, if proven feasible, could be used for a range of applications, eg prestripping, extension of depths for single pass dragline operations and solution of geotechnical problems.

Jan 1, 1992

By Cowie WJ, Utting BS

The alluvial gold industry of New Zealand is based on the placer deposits in Otago and on the West Coast. Production from these since discovery in the 1850's has been an estimated 480 tonnes (15 million ounces) of gold. Annual output has expanded continuously since 1980 and is expected to be over 2 tonne of gold for 1989.Following a historical review, the characteristics of typical operations, which use hydraulic excavators and mobile trommel units are discussed. Descriptions are then given of alluvial activities in Otago and on the West Coast.

Jan 1, 1990

The paper contains the publication of timber shapes recovered from the Burra Mines during open cut operations in the 1970s. The timber was in the process of being disposed of for fire wood. All timber shapes still in existence in September 1990 were drawn.The collection revealed a number of different types of caps and legs. There were also end plates and wall plates from what appeared to be a hanging sets of shaft timber.

Jan 1, 1993

By Barnett LJ

The Kellogg slag fuming model is extended to apply to the Port Pirie plant which uses recuperative heating of secondary air. Exten- sive investigations of plant operations pro- vide parameters for use with the model, and verification that the resulting model provides simulation which is very close to actual plant performance. The model is used to_deter- mine optimum slag fuming operating conditions, and the results of several other investigations with the model are briefly described.

Jan 1, 1975

By Brasnett TC

A wide variety of problems are encountered on a day to day operating basis in the Isa Mine Concentrators. These vary from complex textural problems in the lead-zinc concentrator and their subsequent effect on grinding and flotation to scheduling of converter slag treatment in a chalcopyrite concentrator. With the advent of process control, metallurgists need to specialise and keep up to date with technology improvements. This paper will attempt to describe the significant problems'faced by a Metallurgist û Control.

Jan 1, 1978

In planning and operating mining projects, managers must take into account economic conditions in foreign markets in addition to Australian conditions. As the manager has little influence over the price or the demand for the product, it is particularly important that close attention is paid to the control of costs to ensure that the mining operation remains competitive with foreign producers. This is not necessarily true for some sectors of the domestic manufacturing industry where foreign competition is restricted and costs can be passed on to consumers because of the protection afforded by tariffs. The effects of protection on the cost structure of Australian industry are more pervasive than is commonly understood. The issue of protection is particularly important to the Australian mining industry management because the cost burdens imposed by local protection must be absorbed within profit margins. Furthermore, because protected industries are effectively subsidised to use scarce resources such as skilled labour, the development of more efficient industries such as mining is inhibited. The mining industry has much to gain from any relaxation in protection policy, and hence the issue is of considerable importance to all managers in the mining industry concerned with costs.

Jan 1, 1980

By L Wsrell

During recent years the iron ore industry has experienced a continuous consolidation trend following increased merger and acquisition activities. Analysing and evaluating these mergers is important in order to establish potential effects. The purpose of this paper is to analyse the price effects caused by the merger between Rio Tinto and North Ltd in 2000. The merger was cleared by the European Commission, as well as the Australian Competition and Consumer Commission, shortly after its announcement. The analysis will be conducted using a simulation model based on a proportionality calibrated almost ideal demand system, which uses the premerger situation in order to estimate the post-merger outcome. The relevant market is defined using shipments data. This is followed by the simulation model applied to the defined relevant market. The results show that the concentration on the market, given by the HHI, increases approximately 15 per cent, and that the market share of the new companyÆs reaches almost 20 per cent. Compared to the CommissionÆs assessment the results indicate a more concentrated market and thus a higher concern for possible competitive effects. Furthermore, the results suggest that the predicted average market price increase from the merger is 1.6 per cent. However, the merged firm is able to increase their average price by 5.1 per cent.

Jan 1, 2005

By Rongqing Q, Tiancong Z, Yiyuan L

The influence of pulp density, ferric ion concentration and particle size on the tank bioleaching of two kinds of refractory gold concentrates are discussed. The chemistry and mechanism of the bioleaching process are also presented. The relationship between oxidation of sulphides, liberation of enclosed gold and gold cyanidation are discussed. The consumption of NaCN could be reduced by alkaline treatment of bioleached residues prior to Cyanidation.

Jan 1, 1992

THE following description of the surface plant of the Great Fitzroy Mines is to be understood as having been compiled by a mechanical engineer, who concerns himself more with the various appliances used, their correct construction to enable them to accomplish their prescribed work, and the production and transmission of the power required to operate them, than with the reasons for the physical and chemical processes which those appliances are called upon to assist in carrying out. Hence the metallurgist will not find herein more than the skeleton of the organism, which perhaps he would wish to be clothed with the detailed description of the substances undergoing treatment, in their various combinations, at all stages, and the results attained in separating the valuable constituents from the worthless. So, also, no details will be found of the methods employed by the management for. the purpose of determining by sampling and assaying the nature of the various products obtained.GENERALThe ore being worked at the Great Fitzroy Mine is divided into two classes :-1. Ore that requires concentration before smelting.2. Ore that can be smelted direct.Flow-sheet (Fig. 1) shows in outline the process of treatment to which ore of the first class is subjected, and the writer will endeavour to fill in that outline with some details of the appliances used.

Jan 1, 1911

Blasting effectiveness must be gauged by total production costs. ANFO charges made up in polythene "sausages" are not as profitable as is indicated by the price of ANFO. All-slurry charges are warranted only where blastholes cannot be dewatered effectively, or where drilling costs are very high. An increase in blasthole diameter leads to coarser fragmentation. This effect is most pronounced in tough and massive or blocky strata, or in ground which consists of unfissured boulders in a softer matrix. When ANFO and some slurry-type charges of small diameter are used in plastic-acting ground, charges may fail to detonate through precompression by charges fired on an earlier delay. The optimum blasthole length is rarely less than four times the burden distance. For best results, blastholes should be inclined to the vertical and parallel to the face. Nominal burdens and spacings are often altered radically by the initiation sequence. For best fragmentation, all blastholes must have good effective faces, and should be effectively stagg- ered with an actual spacing:burden ratio in the approximate range 2.0-5.0.

Jan 1, 1975

Western Mining Corporation (WMC), managers of the Windarra Nickel Project, installed a raise-bored haulage shaft and underground crushing system at the Mt Windarra Nickel Mine in 1982. The system is the second of its type installed by WMC, the first being at the Otter Juan Mine in Kambalda in 1976/77. Both haulage systems became necessary as a result of the increasing production limitations, and escalating costs of a deep decline mine.The Windarra haulage system required a single 3 m diameter vertical raise drill hole, 470 m deep and equipped for skip haulage. Two five tonne skips, in balance, hoist crushed ore and mullock to the surface, at a design rate of 200 tonne/hr, effectively reducing truck haulage leads by up to 50 per cent. The system is now fully operational and will enable the mine to achieve its maximum production rate.The raise-bored shaft system has been shown to be cost effective and would be used again in circumstances where raise drilling is applicable.

Jan 1, 1984

By De Janti VP

The automation and centralized monitoring of longwall type underground mining is presently an important subject matter of research in France. The purposes are :to improve safety and working conditions to increase productivity.to improve efficiency in machine operation through continuous "health monitoring". to make winning possible in difficult seams.

Jan 1, 1985

By J P. R de Villiers

The Vanderbijl Park sinter plant in South Africa was investigated to determine the reason for the production of very fine sinter not acceptable as feedstock for the blast furnace. A procedure was designed to generate representative samples and to prepare the samples for chemical and mineralogical analyses. Results from a mineral analyser showed that the samples are extremely heterogeneous and therefore the sampling and sample preparation methods had to be tested in order to produce representative samples. The high production capacity at the sinter plant could also give rise to sampling errors. The method designed involved sampling of the conveyor belt at the sinter plant every four hours for the duration of three days. The samples were then milled and split into smaller sections appropriate for analysis. X-Ray diffraction (XRD) and X-Ray fluorescence (XRF) analyses were conducted on the samples. The results showed a standard deviation of less then one per cent, which indicates that the samples were representative and that the method used was therefore adequate. Systematic differences in the phase proportions between normal and fine sinter samples were detected, with the fine sinter containing more haematite than the normal sinter. The sampling method employed gives added confidence that the differences are real.

Jan 1, 2008

By Carlie JC

Many low sulphidation epizonal gold and zinc-lead vein deposits within magmatic arcs are situated on basement highs, and post-date both the main volcanic episode and porphyry copper (gold) mineralization. These features are best explained by emplacement of a flat batholith a few kilometres beneath each mineral district, as recently demonstrated by geophysical data in the Baia Mare district of Romania. The batholith provides heat for the hydrothermal system, and results in extensional faulting both through up-doming of the overlying rocks, and in some arcs through incipient collapse of the thermally weakened crust under regional extensional stress. More water-rich magmas emplaced at greater depths could explain some deep epizonal and mesothermal gold deposits situated outside magmatic arcs.

Jan 1, 1995

Computer simulation of the control systems for the heavy media coal washing process have been presented in this paper. The simulation model applies the Simulink module of the Matlab 5.1 software package and allows monitoring of variations of a

Jan 1, 1998

By J Player, K Braddon

High productivity mining is the key to the financial success and stability of modern mines. This can be achieved through the use of new technologies, the development of innovative work practices and optimisation of the mining method to suit the mining environment. Big Bell Mine is a 1.7 Mtpa longitudinal sublevel caving operation at a head grade of 3.14 g/t. Annual production is 170 000 ounces of gold. The selection and implementation of bulk emulsion explosives was seen as the logical progression from blow loaded ANFO for the high tonnage rate required from the longitudinal sublevel cave. Prior to the implementation of bulk emulsions an investigation was required to examine the technical and financial benefits available with the introduction of bulk emulsion. This paper examines the review process and the successful implementation of bulk emulsion explosives at Big Bell.

Jan 1, 1999

Within the Business Process Improvement Program initiated at Placer Dome during 2003 was the Business Performance Management Project (BPM).BPMÆ s aim has been to extract productivity improvements from individual business units by providing a model for implementing leading practice based management process within the Placer Dome Group, sharing management best practice, injecting new management techniques and instilling a continuous improvement culture. The installation of an underground dispatch system has been a key component of the BPM project at Osborne Mine.Information capture and analysis allows for corrective action to be planned and executed before there is a material impact on the performance of a business unit. This paper briefly describes the principles and practices of effective business performance management, the four processes of a management operating system namely; strategic and tactical planning, implementation and reporting. The identification of business drivers, their measures and associated key performance indicators is discussed. The benefits of an underground dispatch system at Osborne with respect to safety, production and maintenance is described along with the installation process within the mining department that included its configuration, resourcing and roll out.

Jan 1, 2005

By LeJuge G. E, McKenzie C. K

Innovative mining and blasting techniques were demanded at the Richmont Mines, Francoeur Mine in Quebec, Canada, by a narrow, shallowly dipping high grade gold ore body. The ore body being mined occurs as a thin tabular deposit varying in thickness between 1.5 and 3.7 metres, and dipping at 36¦. The mine proposed experimenting with open stoping techniques using small diameter drill-holes. The hangingwall required progressive, full face rockbolting after each production blast, utilising a specially manufactured machine which provided access to the hangingwall for both scaling and bolting. Blasted material is mucked from the stope by scraper and hoisted directly to surface without benefit of primary crushing.

Jan 1, 1992

By B Leyland

The media in Australia is currently rife with articles and pronouncements on global warming as the most significant crisis of our time, which may æthreaten the future of civilisation as we know itÆ. This has been recently reinforced by release of Al GoreÆs film æAn Inconvenient TruthÆ, and one would be led to believe that the science of global warming is settled. And yet there is a strong body of literature disputing this apparent consensus which suggests that care should be exercised in introducing radical policies to solve a crisis which may not be real. Such policies would have a major impact on those in professions such as engineering (project approvals and design to minimise greenhouse gas emissions), accounting (carbon tax issues) and the law (corporate disputes on greenhouse gas issues are already in train in the USA). This paper addresses the hysteria apparent in the climate change debate by presenting factual evidence relating to climate change and the current phase of mild global warming. Some of the more extreme statements on future impacts are repudiated with published data, and alternatives to the purported role of fossil fuels in temperature change are offered. The potential impact of political decisions on professional activity is discussed, as are the implications of a possible future reversal of the scientific consensus, as has occurred in the past. The paper concludes with a call for the professions to exercise their Learned Society role to ensure that a rational and public debate is held on the broad issue of climate change.

Jan 1, 2007