Search Documents

INDEX OF CONTENTSIntroductionThe slag samplesGranulated SlagGlass-spinel-magnetite-metallic leadRapidly Chilled SlagSlowly Cooled SlagSpinel - magnetite - zinc melitite (hardystonite) willemite - olivine -lead silicate - metallic lead - lead sulphide - copper sulphide - copper arsenide - nickel arsenide.ConclusionsIllustrationsINTRODUCTIONThis paper presents the results of a mineragraphic examination of representative samples of granulated lead blast furnace slags from the Port Pirie Smelter, and of slowly cooled samples of t:b.e same slags, undertaken at the request of the Broken Hill Associated Smelters Pty. Ltd., as part of the research programme of the Mineragraphic Section of the Commonwealth Scientific and Industrial Research Organization.THE SLAG SAMPLESThe chemical composition of the slags examined is given by the following three analyses of the granulated slags, supplied by the Broken Hill Associated Smelters (Table 1).

Jan 1, 1949

The SAG milling circuit at Paddington was designed on limited bench testwork and since commissioning with the exception of some mechanical problems has performed well.

Jan 1, 1987

By Guvenir HA

This paper summarises a cost optimisation procedure by minimising the total drill metres and the overbreak that occurs in tunnel excavation in medium strength rock (uniaxial compressive strength

Jan 1, 1995

By Evans RH, Todd G

Statistical thinking and statistical process ppq;ro4 are essential adjuncts of total quality management aqd too continuous improvement of operating efficiency arid, p*Nc; a4 W,

Jan 1, 1991

By Connor J. W

Nifty Copper Operations was established to treat a copper orebody situated in the East Pilbara area of North West WA, located approximately 70 km west of Telfer in the Great Sandy Desert. The plant was designed to treat the oxidised portion of the orebody with underground development following at a later date. Nifty was designed to produce 16 500 tpa of copper cathode. This will increase with treatment of the chalcopyrite ore (underground resource). Ore processing is similar to other operations of this type but has its unique challenges. Problems discussed are: fine clay minerals which hinder percolation; oxidation of organic by manganese in the electrolyte; crud formation by clays; third phase emulsions; and organic carryover into the electrowinning tankhouse. As the orebody utilisation progresses, some sulphide material will require leaching and further investigations into liquor chemistry.

Jan 1, 1996

By Morley I. W

Offshore minerals legislation has been introduced to provide jurisdiction over the exploration and recovery of mineral resources, particularly petroleum, from the territorial waters and parts of the continental shelves adjacent to coastal states. Ratificat- ion of the 1958 Geneva Conventions on the Law of the Sea has provided some measure of international agreement amongst signatory powers. Because the relationship of the Australian States to the Commonwealth in their federal system, the Australian offshore petroleum legislation is of particular interest. The customary role of the States in mineral resources management, which has extended to the offshore, is under challenge from recent unilateral Commonwealth Government legislative actions in the fields of mineral resources jurisdiction. Environmental considerations provide an additional issue, as yet unresolved, with the delay in submission of the Report of the Great Barrier Reef Petroleum Drilling Royal Commissions

Jan 1, 1974

By Trudinger JP

Mt. Newman Mining Company Pty. Ltd.3 oper ates the Mt. Whaleback iron ore mine in the Ham- ersley Iron Ore Province of Western Australia. The present rate of production of high grade hematite iron ore is 33 million tonnes per year. Mining is by open cut quarrying,with 15m high benches. The present quarry operations will be extended to a large oval pit to win over 1400 million tonnes of iron ore. The pit slopes will extend up to 500m in depth and the perimet- er of the slopes will exceed 15km. Sixty per- cent of the ore is below the water table, which presently lies 45m below the general plain level Dames & Moore, rock mechanics consultants designed the pit slopes during early mine devel- opment to ensure an economic and safe operation.

Jan 1, 1975

All aspects of the development of Ulan Coal Mines are covered - from a small pit pony mine in 1975 to an efficient mechanised underground and open cut operation today.

Jan 1, 1983

Throughout 1992 Pasminco conducted field trials of the Mobile Miner MM130 at Broken Hill. The goal was to develop the machine to achieve acceptable reliability and establish production rates.

Jan 1, 1993

By R Nakia, R Livingstone

Historically the Goldfields of Victoria produced large volumes of gold. Interest in these historical Goldfields has grown over recent years with a view to restarting production of gold. A notable example of this is the Bendigo Goldfield. There is also interest in the Ballarat Goldfield and Ballarat Goldfields Ballarat East Project is a particular example of this. The aim of this paper is to describe the ventilation aspects of the potential Ballarat East project. The mine is proposed as a decline access. The paper gives an overview of the project and in particular the ventilation planning associated with a number of possible equipment scenarios. The paper also analyses the main ventilation pollutants that are likely within the proposed mine as it develops to increasing depth. An attempt is also made to determine the depth at which mine climate will become the dominant pollutant rather than diesel exhaust pollutants.

Jan 1, 2003

The first steps towards the use of artificial intelligence to manage ground conditions have been made. Millar and Hudson (1993) outline the theory behind the use of neural networks in monitoring rock engineering performance.

Jan 1, 1994

Every estimate of ore reserves necessarily contains an assumption in regard to the specific gravity of the ore. This assumed figure may be based on experimental data, on textbook data, or on a reconciliation of past tonnage estimates and production figures. Not infrequently it is simply a guess - shrewd or otherwise.Errors in the density factor are not likely to be serious in gold-quartz mines-or, at least, not so serious as in base metal mines. It is to the closer determination of ore density in the latter that this paper is devoted. Moreover, the remarks apply to ores which show no appreciable pore space.Not many ore bodies are sufficiently homogeneous to allow of a truly representative factor being obtained by the simple testing of a few specimens of ore, or by the weighing, after breaking, of a carefully measured block. The empirical figure derived from a comparison of past ore reserves and actual production can never truly describe conditions other than those now past; no real link with ore as yet unmined is provided. The dilution of heavy ore by waste is not exposed by this method, but is effectively cloaked. Anyerrors in past estimations of ore reserves are transmitted, by way of the density factor, as a source of error in all future estimates.ObjectIons may be raised to the practice of weighing measured blocks of ore in the case of any but a very homogeneous ore body. Even then, the exact composition of the block weighed, and an indication of whether its moisture content is representative of the whole, are difficult to determine.

Jan 1, 1940

Mineral resource estimation is commonly based on the accumulation of a series of local estimates. At times, the distribution of these grade estimates is not appropriate to the grade distribution of the data on which the estimates are based. Mineral resource grade estimation has an increased potential of being in error as the grade variability increases. As the mineral commodity value increases, greater grade variability within the mineral resource is tolerated. This paper directs its attention to mineral properties where the data average grade is 20 per cent or more than the data median grade at a specific cut-off grade. A mineral resource estimate is enhanced if it is supported by graphs which demonstrate that the sample data have been separated into appropriate geological domains. Each geological domain has a unique grade distribution signature, which can be graphically demonstrated simply and objectively. This signature will usually be evident well before the Indicated mineral resource estimates are available. The paper looks at the use of the log probability and MedAve plots to assess how effective domaining has been. It further outlines how the MedAve plot can be used to assess the integrity of the mineral resource grade estimate within a geological domain with the data on which it is based. The paper suggests that the overall grade of a mineral resource at any cut-off grade will be closer to the data median grade rather than the data average grade. Tips are provided to ensure that the odds reflected in the data grade distribution are not ignored and hence the risk that the project is affected by unrealistic estimates of the overall mineral resource grade is reduced.

Jan 1, 2003

The history of the physical chemistry of steelmaking is reviewed through international conferences, and compared with the Japanese contribution. Subjects remaining to be solved are discussed. Several steelmaking technologies developed recently in Japan are surveyed.

Jan 1, 1980

Mining projects frequently fail to meet their financial objectives. A significant area of poor performance lies in the areas of resource estimation, reserve definitions, selective mining and metal accounting. The processes leading to the exploi

Jan 1, 1998

The role of the mine geologist and the exploration geologist have diverged considerably in the last two decades. The principal focus of the mine geologist now is on ore resource management rather than ore resource discovery.

Jan 1, 1997

It has long been recognised that applications of the Net Present Value (NPV) investment decision making methodology can have serious deficiencies in situations where investment can be delayed and, once made, various options allow increases or decreases in the level of output. NPV valuation can undervalue the project if it does not incorporate future flexibilities or ""options"". It is important to realise that a proper valuation of a project (ie, valuation of its future cash flows) must incorporate an analysis of optimal future decisions involved in managing the project. Current valuation cannot be divorced from a consideration of future decision making. There is now a considerable amount of literature, mainly academic, identifying and exploring ways of remedying these deficiencies in the application of NPV. While the necessity of period by period analysis is sometimes acknowledged, little if any practical illustrative model building has been published to date, aside from algorithms using continuous time stochastic processes which deny access to the uninitiated.

Jan 1, 1994

By Pollard D. M

The removal of nickel from lead by sulfur drossing was investigated using a technique which models industrial batch decoppering practice. Successful denickeling to 0.005% (Ni)pb was consistently obtained in the absence of silver, well below the experimental equilibrium value of 0.015% but still above levels obtained in industrial practice. Silver appeared to have little effect upon denickeling. The final nickel content was dependent upon the initial nickel content, the total sulfur addition and the stirring time. The presence of nickel was found to give no assistance to successful decoppering. Simul- taneous removal of nickel and copper was observed at silver contents in excess of 0.02%. Extended stirring resulted in a further lowering of the nickel content but reversion of copper to the bullion was observed. Experimental work has shown that nickel can be removed by a standard decoppering operation; a procedure which is used in secondary lead re- fining. Alternatively nickel can be removed during initial decoppering in primary lead re- fining operations.

Jan 1, 1987

This paper is a summary of the general theory of sampling published by the author in 1975. Sampling is a random process and its the- ory is a study of the, numerous errors liable to take place in the course of its realization. A complete sampling scheme is a sequence of sampling (proper) and preparation stages . At each stage, the total error ET is the sum of : -.Sampling errors EE arising from the selection process itself. -Preparation errors EZ arising from the operations (crushing, transfer...) sup- ported by the sampled material. ET a EE + EZ . At each sampling stage, the (total) sampling error EE is the sum of seven inde- pendent errors : - Weighting error ED resulting from the non-uniformity of the density or rate-of-flow of the sampled material. - Integration error EI1 resulting from the long-range distribution heterogeneity of the sampled material. - Periodicity error EI3 resulting even- tually from periodic quality variations of the sampled material.

Jan 1, 1976

By Houlihan RN, Landau J

A reciprocating plate column is described in which two sets of perforated plates are mounted alternately on two shafts and are reciprocated with a phase difference of 1800 between them. It is shown that such a column is mechanically superior to the previously proposed types: under practical operating conditions the pressure fluctuations at the base of the column are only a small fraction of the static head. Furthermore, mass transfer experiments with the system tributyl phosphate in kerosene- acid aqueous solutions of uranyl nitrate show that both high specific throughputs and reason- ably good efficiencies can be attained in this type of column. A comparison with the more conventional extraction equipment (mixer -settlers, pulsed columns) on the basis of residence time per equilibrium stage indicates the potential of reciprocating plate columns in hydrometallurg- ical application, especially in which the requirements of separation efficiency are modest while the scale of operation is large.

Jan 1, 1975