Search Documents

Dr. Willett. I will start by answering one or two general points which have been posed. The first point is a question of liability of a seam to spontaneous combustion. Some seams are very liable to spontaneous combustion. Some seams are not liable at all except in most abnormal circumstances, and some seams have a liability somewhere between these two extremes. Dr. J. S. Haldane made the comment some 50 years or so ago that if you try hard enough you can make any coal seam in the world fire spontaneously. Many heatings have in fact occurred because the coal has been allowed to be ground up into a fine state and there has been air leakage through it for many years. This has resulted in spontaneous combustion which would not have occurred in some seams unless conditions had been very abnormal indeed. One comment I heard while listening to the discussions of one team was the importance of encouraging morale and the team seemed to go to the extent of suggesting that this was more important than the actual technical action taken. Though I agree that everything possible should be done to encourage morale, it must be in conjunction with the correct technical method of dealing with the Emergency.

Jan 1, 1973

By D Stow, R Goodridge, K J. Molloy

A range of explosives has been specifically developed for soft ground blasting. These explosives can be used in both wet and dry blasting conditions, range in density from 0.3 - 1.2 g/cc and range in VoD from 2 - 4.5 km/s. This range of explosives has the potential to be tailored to ground type and is predicted to be suitable for a variety of applications which include: blasting in soft to medium overburden, coal blasting, wall control, and low vibration blasting. Trials have been conducted in several applications with encouraging results. Several cast/throw blasts have been conducted with these products partially replacing either ANFO or Heavy ANFO. The results from the blast have been equivalent in cast (per cent) and at reduced cost per unit volume. These products have also been used in presplit blasting and have again achieved equivalent or better results when compared to conventional presplit blasting at a lower cost per unit volume. This product has also been used in a vibration sensitive area replacing traditional explosive products, and generating excellent fragmentation and digging whilst maintaining vibration limits. This new range of products, NOVALITE, has shown great potential in many applications either reducing cost per unit volume, improving wall quality or improving productivity in environmentally sensitive areas.

Jan 1, 2001

Geosynclines have been well studied for many years, but very little has been written about the concepts of sedimentary basins in spite of the vast amount of data available. They have been regarded, perhaps, as well- understood intuitively, and therefore not worthy of study. Many of the fundamental concepts of geology were developed during the 19th Century with the construction of coal mines, canals and railways. It was a happy chance that led railway engineers in the early days to think that trains could not climb any but the smallest gradient, so, in Britain at -least, numerous railway cuttings and tunnels were made. These exposed to view and study, in a better form than Nature usually provides, a great deal of interesting geology. Because of the lack of literature about the concepts of sedimentary basins, it is not possible to be sure what the early geologists thought. It seems that sedimentary basins were regarded as recording a history of subsidence during the early stages, when a transgressive sequence accumulated; and a history of uplift during the later stages, when a regressive sequence accumulated. It seemed axiomatic that the age of folding and faulting was younger than the rocks folded or Faulted.

Jan 1, 1987

By Johnston G, Joyce C

The permitting of new mining projects has evolved into a highly complex process that must be carefully managed. Only by developing a thorough understanding of the issues involved and stakeholder interrelationships can successful strategies be developed that integrate the often competing demands of: ò regulatory requirements, ò commercial requirements, ò social/cultural needs, and ò technical issues. Properly implemented, this approach can result in: ò shortened approval timeframes, ò better project definition ò broad based community support, and ò favorably disposed government departments.

Jan 1, 1997

Aspects of sampling are becoming more complex, involving a correct statistical approach to collection as well as geological and possibly pedological control. Advanced chemical techniques and techniques of rapid analysis need to be understood. Results may require statistical analysis. The elementary aspects of sampling still need constant attention by those controlling a programme of sampling. No one person will have sufficient knowledge of statistics, geology, pedology and chemistry to be fully conversant with all the aspects of sampling but, by developing a correct approach, problems can be identified and solved.

Jan 1, 1976

In the face of intense global competition and other business pressures on coal miners, ongoing quality initiatives and continuous process improvements are needed to enhance business performance. By viewing a minesite in terms of key processes, rather then departments, and employing innovative technologies and better applying organisational resources, there exists enormous potential to achieve reductions in process cost and time.

Jan 1, 1998

By K Inoue

The pressure oxidation of molybdenite concentrates in acidic and alkaline media has been studied. The conditions of the selective oxidation of copper and iron sulphide minerals with a quantitative copper leaching by ferrous-ferric-sulphate solution have been found and explained from the point of view of electrochemical kinetics. The partly oxidised residue consisting of molybdenite and (hydro-) oxide of iron (III) was then decomposed by oxygen in alkaline media. Effects of the main parameters, such us oxygen pressure, leaching temperature, solid-liquid phase ratio, autoclave stirring speed as well as lixiviants nature on the molybdenite oxidation rate have been established.

Jan 1, 2000

The paper reviews the majority of associations and institutions which operate in support of the Australian mineral industry. The review covers historical aspects of each organisation and the current activities and management structure. The linkages between the organisations through membership are briefly discussed. The paper comments on the evolution of the formation of the organi- sations and the networks between them that do exist and operate regu- larly. Rationalisation or a process to consider formation of new groups to fill gaps in the network are recommended for further research.

Jan 1, 1988

By Choulaj D

Mining and petroleum continue to be the two most vita components of our nation's development, says Sir Julius Char in the Australian Journal of Mining (Nov-Dec 1996). In fact the} account for 71.6% of export earnings, and 21.2% of Gros; Domestic Product in Papua New Guinea. The Misima and Porger, Mines, along with the Kutubu oil project, have essentially rescues PNG's economic viability since the loss of income from Panguna Though the industry cannot create employment in the manner o. intensive industries such as agriculture, it does provid( opportunities to local communities in terms of jobs, financia compensation, and infrastructure. Many ventures take many years and enormous capital investment to set up. There are three phases: exploration, feasibility, an( operations. The operations phase sees a massive development o infrastructure, or the actual `building' of the mine. For mining companies to commit to such lengthy time frames and high level: of investment, without returns, requires confidence and a degree of commitment from government on a number of levels - legislative stability, monitoring social development, and the provision o social infrastructure.

Jan 1, 1997

Looking back 25 years, the role of the drill and blast engineer in an Australian mine seemed relatively simple, with the primary focal points being scheduling of the drill rigs, oversize control, and budget control with respect to consumption of both explosives and drill consumables. The choice of explosive selection was relatively simple, though many mines were becoming involved in trials of slurry explosives, emulsion blends, and low density ANFO blends. Guidelines to assist the engineer towards specific fragmentation targets were scarce, environmental constraints were light, and computers were rarely found on the desks of any mining engineers. Wall control blasting was in its infancy, with the bulk of attention being given to appropriate slope design and little real attention given to factors such as explosive distribution, and optimum delay timing and sequencing. Quantitative measurement of blasting performance was rare. The science of blasting, for fragmentation control, wall control, and environmental impact control was about to be born, and was heralded in those years by intense efforts by the explosive manufacturers and a proliferation of research centres throughout the world. Since the early 1980s, the role of the Australian drill and blast engineer has gone through a major metamorphosis, and currently requires a greater depth of scientific understanding than any other specialisation within mining engineering.

Jan 1, 2004

The Department of Conservation (DOC) manages public conservation land throughout New Zealand in terms of section 6 of the Conservation Act 1987. In brief, this requires DOC to manage the natural and historic resources of the land; promote the benefits of conservation to present and future generations; provide information about conservation; to foster recreation on the land; and allow for its use for tourism.   Locally the department's Tauranga Area Office manages approximately 60 000 hectares of Conservation Park (known as the Kaimai-Mamaku Forest Park) which includes early gold mining relics and former bush tramways associated with the logging and the mining industries. The Department has recently developed the Kaimai Heritage Plan which seeks to restore some of the relics and encourage involvement by the local communities in the restoration and interpretation of their history in the hills. It provides a unique opportunity for the Department to help bring alive for New Zealanders an important, and often overlooked, part of our history as a nation in a stunning natural setting.   The purpose of this presentation is to: +        display the endeavour and ingenuity of the early miners and loggers, the relics of those industries and the dramatic environment in which they worked; +        identify the linkages between those early industries and gold mining today; and +        promote a co-operative approach to heritage and recreation management involving all facets of the community.

Jan 1, 2006

By S E. Box, J L. Mauk

The Middle Proterozoic metasedimentary rocks of the Belt Supergroup contain important metallic mineral deposits like the diagenetic sediment-hosted stratiform copper mineralization, including the Troy (Spar Lake) deposit and the epigenetic hydrothermal veins in the lower Belt and Ravalli Group in the Coeur d'Alene district. Magnetite (Fe3O4) is a common and widespread accessory mineral in these rocks and can have multiple origins including ore stage in deposits, mobilization stage in source rocks, metamorphism of red beds and alteration mineral in thin halos enveloping Ag-rich veins in the Coeur dÆAlene district. As shown in several classic studies, the composition of magnetite from igneous rocks varies significantly in response to controlling factors such as melt composition, temperature, silica activity, and oxygen and sulphur fugacity. Therefore, the distinctively different geologic settings within the Belt Supergroup strongly suggest that there may be differences in the magnetite compositions. However, initial microprobe analyses detected no variation in magnetite composition.   Three possibilities may give an adequate explanation for these initial results: 1.      the magnetite formed primarily as pure Fe3O4, 2.      one or more tectonothermal events led to regional scale re-equilibration that affected all rocks in the field area, and 3.      the variations in the composition are below the detection limit of the microprobe.

Jan 1, 2007

Although the flotation cell has been under continuous development over the past 80 years, an understanding of the precise roles of a cell in produc- ing the flotation result had evolved slowly. In fact, detailed studies of cell dynamics began only in the 1940s when flotation practice had almost reached the half-century mark. The earliest generalizations related cell capacity to power intensity (hp/vol- ume) (Rose, 1946), and specific operating features such as aeration and power ' consumption to impeller submergence and operating speed (Read, 1933). In the 1950s hydrodynamic characterization of cells through power coefficients and air flow numbers began (Arbiter and Harris, 1961) and has continued to the present, with increasing industrial use of these concepts (Degner, 1982; Degner and Treweek, 1976). Liquid flow measurements in Wemco cells (Degner, 1982) made liquid flow numbers and turnover frequencies available for more complete under- standing of cell dynamics. The present overview of flotation technology is a critique of cell design. The cell process represents the interactions between cell dynam- ics, cell geometry, and ores, with the latter prepared for that interaction through size reduction and reagent treatment. While previous invest- igations of flotation cells have accepted all cell designs uncrit- ically, the present study considers the physical process components that an effective cell must provide, and then compares a limited number of

Jan 1, 1984

Study on the Recovery of Zinc Minerals from the Tailing of a Lead and Zinc Mineral Processing Plant

Sep 13, 2010

In 1952 when universities imposed fees on students and most students won either Commonwealth or Government department or private scholarships to study, I won a scholarship to study mining engineering at the University of Technology in Sydney. The univ

Jan 1, 1994

The Benambra deposits, which are regarded as volcanogenic in origin, may be subdivided into two major bodies, termed the Wilga and the Currawong deposits; these are further subdivided into smaller, more manageable units, based on composition and structure/spatial distribution.

Jan 1, 1989

By Borkin AD, Yemelyanov MF, Otrozhdennova LA, Malinovskaya ND, Nechay LA, Koltunova TY

The results of investigations of reagent regimes and flotation machines to decrease the losses of valuable components in both coarse and fine particle classes during non-ferrous metal dressing are considered.

Jan 1, 1993

Aspects and anomalies in the present Standard Specifications for Blended Cements which may have operated in Australia against the development of the greater use of Slag Blended Cements are noted. Estimates of slag and ash usage in Australia are given and the need for further research with local materials stressed.

Jan 1, 1979

By Linge H. G

The effect of sodium pyrophosphate and several polyacrylate deflocculants (Freevis 502, 528, 529 and 532; and Maxfloc 1015) on the gold loading on Calgon GRC22 and Norit R035l5 carbons was tested and found to be insignificant in a pulp free enviroument. These deflocculants can therefore be used in plants processing viscous gold pulps without fear of fouling the carbon.

Jan 1, 1990

The general characteristics of bauxite deposits in Temporary Reserves held by Bauxite Exploration Pty. Ltd., Western Australia are briefly reviewed. The deposits (slide) are 'near the eastern limit of the bauxite laterite cap which masks the basement rocks of the Darling Range.

Jan 1, 1964