Search Documents

By M Hino, Y Sasaki

Sustainable handling of municipal waste and sewage sludge has an important goal to recycle resources without supply of harmful substances to humans or the environment. The gasification mechanism of phosphorus from municipal waste and sewage sludge during the incineration process has been investigated to develop a phosphorus recovery system. Quadrupole mass spectrometer coupled to an electric furnace is applied to study the vaporisation behaviour of phosphorous gas phases from municipal solid waste (MSW) incinerator ash of sludge during solid-state reduction by carbon. Measurements are carried out in vacuum conditions of 2 x 10-6 Torrs and furnace temperature range 573 - 1773 K, at a heating rate of 7.22 K/minute. It has been found that most of the phosphorus is vaporised as PO2, P2 and P4, in agreement with thermodynamic estimation despite a shift in the temperature regimes.

Jan 1, 2006

In-seam drilling is conducted mainly to drain coal of gas and/or water prior to development or extraction. The requirements of inseam drilling for gas drainage have mainly surpassed the technical limits of rotary drilling and are mainly being addressed by guided down hole motor drilling, albeit at a higher cost. There is an increasing application of in-seam drilling to detect geological structures or other hazards or their absence in advance of mining to reduce the risks of underground mining. Close collaboration between miners, drillers, geologists, researchers and suppliers over the last four years has seen many advances made to improve the accuracy and reliability of inseam drilling. With such developments will come closer control over the ventilation and safety of future mining under deep gassy conditions, but not without costs. The paper summarises the current applications of inseam drilling, recent technological advances and the next generation survey and geophysical sensing tools which are currently being developed

Jan 1, 1998

The energy crisis and the general increase in fuel prices have changed the position of coal in the world. Countries need to review their policies on coal, depending on available reserves and their accessibility. On the demand side, a distinction should be made between the steel industry's specific demand for coking coal and the needs of power stations where coal is used in competition with other sources of energy. Coal consumption in these two sectors is expected to increase considerably over the foreseable future. Some countries have sufficient coal of their own to meet this increased demand but others will have to rely on imports. As a result, the tonnage of coal transported by sea may double by 1985. The coal industry lacks flexibility. The opening of new mines and the construction of a transport system to ship the coal takes time. This time-lag, coupled with the enormous expenditure involved, makes long-term contracts between producers and consumers essential.

Jan 1, 1975

I wish that in addition to being a Pro- fessional Engineer I was also a communications expert. My principal task this morning, and yours after this meeting, is to convince a wide variety of individuals that steel industry slags are a high quality material that can be used for many purposes; and that their use can significantly alleviate some of the problems facing engineers, public officials, and the general public in our countries. By actual in- place performance over a long period of time steel industry blast furnace slags have proven that they are as good as the best natural aggregates, and better than some, for any type of construction or purpose for which natural aggregates are used. Steel furnace slags have many unique favorable characteristics and prop- erties when compared to other types of aggre- gate even though they cannot be used for all types of construction. We have the facts, all we have to do is present them to the right people in the proper manner.

Jan 1, 1979

By Walter GW

Rock mass classification systems for stable excavation design have been studied. The parameters which are important in such a classification system and those which should be included in a classification system formulated to predict explosive fragmentation behaviour are briefly reviewed and compared. There is significant overlap in the data requirements for excavation design and explosive blast de- sign. Recently there has been a trend to ob- tain some of the data required for excavation design by the use of both field and laboratory seismic investigations. The theory of seismic techniques is summarised and the results of seismic investigations carried out for excava- tion design are reviewed. On this basis it is considered that seismic techniques have the potential to be used for data collection prior to blast design. A programme designed to de- velop such techniques and which includes both field and laboratory experimentation is Presented.

Jan 1, 1978

Geological models for the exploration and evaluation of epithermal Au and porphyry Cu-Au deposits rely upon a classification of different deposit styles and an understanding of the evolutionary processes of deposit formation. These models guide the interpretation of subsurface deposit anatomy in order to target drill testing and assist the explorationist to focus on the more prospective projects. It is important for the explorationist to distinguish between different styles of magmatic arc Au deposits as each style displays distinctive characteristics with exploration implications. Magmatic arc Au deposits are distinguished as porphyry Cu-Au formed at depths of 1 - 2 km at the apophysis to larger, buried, magmatic sources which are also the ultimate metal sources for the varying styles of shallower level epithermal Au deposits. Low sulfidation epithermal Au deposits characteristically develop from dilute circulating meteoric waters and are distinguished as the group with a closer relationship to intrusive source rocks, and slightly higher sulfide contents (still generally

Jan 1, 2004

THIS paper is not intended to be more than a mere outline of the economic geology of Tasmania. It is desired to present in a condensed form the present state of our knowledge in regard to the distribution of the ore, coal, and oil-shale deposits of Tasmania in time and space.Tasmania is exceptionally well endowed with mineral wealth, particularly in the north-western and western districts. In the enthusiasm resulting from the first discoveries of mineral deposits at a great number of localities in those districts, it became a generally accepted belief that the whole of that portion of Tasmania constituted a continuous metalliferous province. As geological research in these, areas has progressed, however, it has become increasingly clear that ore-deposition has been confined on an economic scale to definite well-defined areas or belts which have a genetic relationship to certain tectonic and petrologic phases of the general geology. These areas or belts have recently been defined by the writer, and...

Jan 1, 1923

By Jia X

Three-dimensional microscopic modelling techniques involving specific calculations based on direct computation of the Brownian, van der Waals, Born, electrical double layer repulsion, bulk, hydrodynamic and external forces (gravity, magnetic etc) acting on and between each particle in a mineral dispersion are now feasible using advanced computer processor architectures. This contribution surveys the hardware requirements, the advantages and limitations of the approach for enabling prediction of dispersion behaviour a priori. The notion of developing a generic particle simulator, akin to the use of molecular modelling in the area of drug design, based on inputting process-relevant data (solution chemistry, mineral solids properties, hydrodynamics etc) is discussed. The methodology is illustrated with application examples involving: predictions of coagulation of mineral fines; shape and size of magnetically-flocculated hematite; and the kinetics of fouling of membrane surfaces and walls.

Jan 1, 1993

The organisers of this function have suggested that this presentation should accomplish the following broad goals:set the technical tone for the conference to follow, implying some discussion of the æstate-of-the-artÆ of reserve estimation; and raise some current and common problems or deficiencies in our art in order to be thought provoking. As an engineer it is always easier to raise problems than to solve them with state-of-the-art. Consequently, I have had to limit the extensive list of problems that could have been discussed within this presentation. In regard to the state-of-the-art, this presentation will not be an esoteric discussion of the latest statistical estimation processes, although I intend to challenge those with skills in that area to address some of the thought provoking issues later on. The subtitle of the paper was established after reading an excerpt from æLife on the MississippiÆ by the American humorist Mark Twain in which Twain observed that the Mississippi River had become shorter during his working period on the River due to natural cut-offs and man made channels. Projecting into the future, he calculated that by now, Cairo, Missouri and New Orleans, Louisiana would become a single city with one mayor (the two cities are still separated by some 500 air miles). As a moral to this story Mark Twain observed that one can obtain: æwholesale returns of conjecture out of such a trifling investment of factÆ.

Jan 1, 2000

By Jagger N. D

Lead residue from the Zinc Leach Plant at Pasminco's Port Pirie Lead Smelter was previously filtered on a vacuum drum filter and further dried in a gas fired rotary kiln prior to stockpiling and transport to the Sinter Plant. This process involved several materials handling stages, recycled significant amounts of zinc and often resulted in poor environmental conditions. These problems have been overcome by pumping the thickened leach residue approximately 450m to the Sinter Plant where it is filtered in a Larox Automatic Pressure Filter. The filter cake is discharged onto a conveyor belt, held in a storage hopper and then fed directly to the main sinter plant feed stream. Filtrate is returned to the process for additional zinc recovery. The laboratory and pilot plant filtration results are briefly discussed and compared with the operating plant data. The filter installation and ancillaries are described in detail along with the commissioning, operating and maintenance experience over the past 4 years. This installation has overcome the environmental and materials handling problems and resulted in annual savings of approximately $1 million.

Jan 1, 1989

By Hoberg H, Schnieder FU

The disposal of residues from coal preparation and processing will to an increasing extent require investigation and consideration of the environmental problems resulting as a consequence of this. Different authors (Diingelhoff and Plankert, 1983; Hasenpatt, 1985; Szczepanska and Twardowska, 1987) have concentrated primarily on the content and the mobilisation of inorganic contaminants such as chlorides, metals and heavy metals from spoil tips, while no publications have yet been found on the question of a possible emission of organic contaminants (PCB, PAH, HC HC) from processing residues. Here the flotation residues in particular are able to bind larger quantities of organic contaminants by physi-sorptive means because of their large specific surface and, after disposal, to be re-emitt than into the environment. The flotation agents used in coal flotation are mixtures of technical distillation products with a correspondingly fluctuating composition. As Hey, 1986 showed, they may contain, in addition to the main components (n-alkanes, alcohols, surfactants), over 50 individual trace substances. In conjunction with the structural-chemical similarity of the individual components, this complicates the quantitative analysis of individual components considerably. For the analysis of hydrocarbon content of flotation products by means of extraction with organic solvents in accordance with DIN 38408, H18, the difficulty arises, besides the insufficient sensitivity at low concentrations, that geogeonic hydrocarbons are extracted from the coal as. well and the analysis results are thus falsified. These problems were overcome by the application of the 14C radiotracer method where certain components of the flotation agents are marked with radioactive carbon (14C). By measurement of the radioactivity of solid and liquid samples, the concentration of the marked substance can be measured very sensitively and precisely, whereby the accumulative measurement of similar organic substances is ruled out. Thus the reaction path of certain substances in complex reagent mixtures such as flotation agents can be traced excellently and the conceivable environment burden resulting from flotation tailings disposal can be estimated. In this paper, the adsorption behaviour of typical components of coal flotation agents are investigated for different coals and types of gangue material, the reagent content of flotation concentrates and tailings, as well as the mobility of the reagents adsorbed onto solids. The knowledge of adsorption and desorption mechanisms of unpolar hydrocarbons emulsified in water to solids are also of particular interest for the understanding of processes of organic soil contamination and for the further development of washing processes for oil-contaminated soils.

Jan 1, 1993

Criteria for the manipulation of commodity markets are discussed. Against the economic background of the past twenty five years actual attempts to manipulate markets are evaluated.

Jan 1, 1985

By Budd B

this paper outlines the operating advantages gained through applying a mine processor (MISA), to various underground and surface operations. On the surface, MISA monitors and/or controls ventilation fans, crushers, fill plant and stockpiles. Underground, MISA monitors and/or controls dewatering pumps, fill reticulation and high voltage electrical distribution on most levels.

Jan 1, 1988

Acid rock drainage (ARD) derived from sulphide oxidation and the associated metal leaching is the most significant environmental issue facing the mining industry today. Under given hydrological and biogeochemical conditions, the local geology and mineralogy largely control the formation of ARD. The involvement of a geologist is therefore essential in minesite ARD assessment and prevention. The relevant tasks that a mine geologist may undertake at three major phases of a mining project are briefly described. Additional knowledge that a mine geologist should acquire in order to achieve proficiency in ARD assessment is also suggested.

Jan 1, 1993

The cost of constantly extending a decline tunnel that plays a part in the actual extractive process is a revenue cost. The characteristics of such a decline tunnel are that it is dug in a series of relatively small excavations. It follows the ore body and is dug as close to the ore body as practicable. In addition, the decline allows for the extraction of ore in the immediate vicinity, with the ore being extracted in a relatively short period of time.

Jan 1, 1990

By Satayev IS, Shepelev DV

Various ways for applying the X-ray fluorescent method to process lump-by lump separation of secondary aluminium raw materials (scrap, slags, waste) as well as ferrosilicon and ferrochromium are being considered and physically demonstrated. A commercial X-ray radiometric sorter has been developed for processing secondary raw materials. Marketable quantities of aluminium scrap with appropriate copper and zinc content have been produced for smelting with a minimal additional of pure aluminium. An industrial complex for scrap processing, incorporating two X-ray radiometric sorters from the Hammermils company is successfully operating at one of the works in Russia.

Jan 1, 1993

By Kwok S, Haemmerle A

Treatment methods for a low grade deposit at Mt. Fitch near Rum Jungle, N.T., were investigated. Physical beneficiation of the ore, sulphuric acid leaching, carbonate leaching and various methods of uranium extraction from the leach liquor were studied. Although the deposit occurs in a carbonate environment, acid leaching of the ore after beneficiation by radiometric sorting appears to be the most economic treatment method. Uranium would be recovered from the leach liquor by solvent extraction.

Jan 1, 1970

By Burrell I

This paper describes recent developments at West Cliff Colliery in environmental monitoring, using a sophisticated computer controlled system. The operations involved in environmental monitoring are described and the equipment employed is detailed. It is anticipated that the monitoring system employed at West Cliff Colliery will be expanded to allow total and instantaneous monitoring of roadway environmental Conditions.

Jan 1, 1983

In his letter of resignation as General Superintendent of the Broken Hill Associated Smelters (BHAS) prior to taking up aconsulting position at imperial Smelting, G.K. Williams wrote that he considered his major contributions at BHAS were:the development of large scale sintering machines;the double tuyere-row blast furnace; continuous lead refining.Despite his well deserved reputation as a scientist, based on his advancement of the metallurgical chemistry underlying lead refining processes, Williams reveals that he considered commercial implementation as the ultimate measure of technological success. Furthermore, he clearly did not differentiate between the scientific and the empirical as a means of achieving that end.

Jan 1, 1985

By D R. van der Meulen, P Ande, D J. Lunt

Pressure hydrometallurgy is becoming an increasingly common unit operation in the treatment of gold and base metal ores and concentrates. The design of an adequate and appropriate pilot-scale testwork program is, therefore, essential in order to minimise the risks associated with developing a project in which autoclaves form a key part of the operation. This paper identifies the approaches that have been taken in the piloting of oxidative and pressure acid leach operations. Particular emphasis is placed on the determination of scale-up ratios between the pilot and commercial plants and the pilot-plant run durations. The issues, both metallurgical and project-specific, that can impact these key parameters are reviewed.

Jan 1, 2004