Water Balance Management

My recent experience has been with wet tropical environments, which address a different set of concerns than Nevada, for example. Spraying rather than drips are required in most cases just to assist the water balance requirement, and my comments address those situations. Most tropical operations are faced with both extremely wet and very dry seasons, with some having multiple cycles during the year. A heap leach operation must address the rate of solution building up within the ponds and how long the volume must last until the next rainy season. It may be easier to construct sufficient pond volume to permit yearlong operation than by discharging excess solution now, and searching for water later. Pond capacity requirements can help with the following: Consider using the solution that could be locked up in the pads during leaching to assist water balance problems. Spray excess solution continuously onto spent ore that would not be normally be sprayed again to "soak up" the excess solution, and stop spraying when the water balance is low, allowing the solution in the spent ore to return back into the system-with or without cyanide added. In a multiple lift system, if intermediate HDPE liners are planned for solution grade control, have drips placed before the HPDE liner is in place. The drips can distribute excess precipitation throughout the lower lifts to control the water balance, while the most current lifts are being leached and sent directly for the preg pond. With only 2 million tonnes (2.2 million tons) of spent ore involved, up to 200,000 cubic meters (53 million gallons) of solution could be moved into or out of the water balance system, if proper methods are designed and installed. That is equivalent to one meter (40 inches) precipitation falling on a 200,000 square meter (2.2 million square feet) pad area. You may even get a little bit more gold recovered as the solution drains from the earlier pads, as well.