Vertical Cutting

From time to time the question of shearing or vertical cutting of rooms and entries especially as an adjunct to the usual horizontal cuts, has cropped up in the literature of coal mining and in the discussions of mining men. Exact and definite data based an thorough tests have usually been lacking however and the present article is written to supply as far as possible this deficiency. The tests given below were made over a period of 90 days in the summer of 1921 and the object was to investigate the general .economics, if any, that might result from the introduction of vertical cutting as a standard practice into the Clear Creek mines. The machine used was the Oldroyd Universal coal cutter and comparative tests were made against the Goodman Straight- face machine and the 35 B Jeffrey Shortwall. The tests however should be held to apply only to the various methods of cutting and not as a study in the relative merits of the various machines. The first series of tests were made in the 2nd East district of No. 3 mine, where only entries were being driven at the time, the tests therefore cover only entry work. The presumption was that the entry width would be 12 feet but the oxerrun in some cases was marked enough to make the work comparable to rooms. The first test made was to determine the time necessary to shear as well as cut the places, and the results were reduced to the time necessary to cut a ton of coal. The time for shearing in the table includes the time necessary to revolve the cutter bar to the vertical position.