The Alamo Mine

The Alamo Mine The Alamo mine is located about seventeen miles northwest of Walsenburg, Colorado, on the Loma Branch of the Denver and Rio Grande Western railroad, in the foothills of the Black Mountains of Huerfano County. Prospecting Mr. W. B. Lewis of New York City, president of the Oakdale Coal Company and also president of the Alamo Coal Company first became interested in this property in 1920. After all natural features of the surface had been carefully examined by Mr. Lewis, he was convinced that the property was underlaid with coal seams. Plans for prospect drilling were made at once and this drilling was started late in 1921. In all, eight drill holes were put down to the Trinidad sandstone which underlies the coal measures in this field. These drill holes in general, showed very satisfactory results. Two workable coal seams were penetrated by most of these drill holes, the upper seam being six and one half feet thick and the lower seam having a thickness of ten and one-half feet. The two seams are separated by forty feet of sandstone and shale. Analyses of the seams proved each to be of a very high grade bituminous coal possessing hardness much above other bituminous coals, and having very bright lustrous appearance. Tests of more than a year's duration proved the coal to store excellently in closed bins and also in open bins where coal is exposed to elements. The drill hole data further showed the coal seams to pitch more than fifty per cent or about twenty-six and one-half degrees. The pitch direction being approximately South 65 degrees East. The drill holes further proved the coal seams did not outcrop at any point on the property, and no evidence of coal outcrop has been found in near vicinity. A splitting and pinching out of seams was found to occur some two hundred to three hundred feet of theoretical outcrop at very Western boundary of property. The most Easterly or No. 6 drill hole has a depth of eight hundred fifty feet to floor of lower coal seam. The Trinidad sandstone was found to be immediately under the lower coal seam, and the Pierre shales lying under this sandstone. Plans for Development and Sinking Having obtained sufficient data, plans for development of the property were carefully made sometime in advance of the actual opening of the mine. Every condition was carefully studied and the maximum production of clean and well prepared coal at as low a cost as possible during the entire life of mine was kept uppermost in the minds of all. The life of mine is estimated at approximately fifty years. It was decided to open up the lower and thicker seam first, and due to the pitch and other conditions a slope opening was decided upon for its extraction. The pitch of the coal having been found to be from fifty to sixty per cent or twenty-six to thirty degrees, the plan of driving the slope directly down the pitch of seam was eliminated and a plan that would give a more economical grade was decided upon. To obtain a lesser grade, a point several hundred feet west of-and at a less elevation than the theoretical outcrop of coal seam was selected for the slope opening. (Fig. 18.) To have driven directly down the pitch of coal seam would also have given the slope an uneven grade as the pitch of coal seam varied as it approached the crop. From this point of opening, the slope was to be driven on a thirty-one per cent, or' about seventeen degree pitch to intersect coal seam in No. 6 drill hole, a distance through the Pierre shales and Trinidad sandstone of two thousand five hundred fifty feet, the slope to be driven practically due East