Technical Approach to Lining Design for Internal Pressure and Fault Offsets on the JWPCP Effluent Outfall Tunnel

Society for Mining, Metallurgy & Exploration
Jan Van Greunen Yiming Sun Geoffrey Hughes Roozbeh Geraili Mikola David Haug Mark Vanderzee
Organization:
Society for Mining, Metallurgy & Exploration
Pages:
11
File Size:
640 KB
Publication Date:
Jan 1, 2016

Abstract

"The Sanitation Districts of Los Angeles County is planning to construct a new, approximately 7-mile-long (11.3 km) effluent outfall tunnel to be excavated by TBM and lined with precast concrete segments. Anticipated net operating pressures within the tunnel are expected to approach 3 bar. To counteract joint opening and exfiltration leakage, an approach has been investigated to post-tension the precast concrete tunnel lining with steel tendons. The tunnel alignment crosses several seismically active fault zones, at which installation of steel pipe is proposed as a secondary inner lining to mitigate potential offset displacements. This paper discusses the tunnel lining design approach and methods used to address these unique challenges.INTRODUCTION The Sanitation Districts of Los Angeles County (Sanitation Districts) is planning to construct a new 18-foot-diameter (5.5 m), approximately 7-mile-long (11.3 km) tunnel from the Joint Water Pollution Control Plant (JWPCP), located in the City of Carson, to the existing White Point outfall manifold structure at Royal Palms State Beach (RPSB) (Figure 1). The project is part of the Sanitation Districts’ Clearwater Program, which will improve overall system reliability through the repair and replacement of the existing aging infrastructure. The existing system includes two 6-mile-long (9.7 km) tunnels, 8- and 12-feet in diameter (2.4 and 3.7 m), and four ocean outfall pipes with a maximum capacity of approximately 675 million gal/day (MGD) (2.6 billion L/day). Addition of the new parallel tunnel will increase overall capacity to accommodate peak wet weather wastewater flows of up to 1,262 MGD (4.8 billion L/day) and will allow inspection and repair of the existing tunnels. The new outfall tunnel will be excavated using a pressurized face tunnel boring machine (TBM). Shafts at the north (JWPCP Shaft) and south (RPSB Shaft) ends of the proposed alignment will connect the tunnel to the existing wastewater treatment plant and existing ocean outfalls manifold and during construction act as launch and receiving shafts for the TBM. The tunnel will be excavated from north to south as a single heading."
Citation

APA: Jan Van Greunen Yiming Sun Geoffrey Hughes Roozbeh Geraili Mikola David Haug Mark Vanderzee  (2016)  Technical Approach to Lining Design for Internal Pressure and Fault Offsets on the JWPCP Effluent Outfall Tunnel

MLA: Jan Van Greunen Yiming Sun Geoffrey Hughes Roozbeh Geraili Mikola David Haug Mark Vanderzee Technical Approach to Lining Design for Internal Pressure and Fault Offsets on the JWPCP Effluent Outfall Tunnel. Society for Mining, Metallurgy & Exploration, 2016.

Export
Purchase this Article for $25.00

Create a Guest account to purchase this file
- or -
Log in to your existing Guest account