Sampling and Estimating Ore Deposits - Estimating the Cuyuna Iron Ore District, Minnesota

Because no rock outcrops exist in the Cuyuna district, it is necessary first to make a magnetic survey with a dip needle, or possibly with a sun-dial compass, and determine the area or belt of magnetic variations and the maximum lines of magnetic attraction. A dip-needle survey is quicker to make, is sufficiently accurate, and will suffice. Regardless of how poorly defined the magnetic attractions may be, it is important that they be determined. Even if drilling has developed ore on an adjoining property, the survey should not be omitted. Iron-bearing formation is indicated by the magnetic attractions, but whether or not ore exists must be determined by drilling. The maximum line of magnetic attraction offers the best place to begin drilling. If no magnetic attraction exists, nearby developments are the only guide; and if these also are lacking, drilling is governed by guess. Test-pitting is not employed in exploratory work because the surface is too deep. Tunneling cannot be used because the topography is not suitable. Exploration shafts are a waste of time and expense, because from every standpoint drilling with churn and diamond drills is the most applicable method for exploratory work. Light drilling equipment only is needed. Rarely have heavier drills been required, for seldom do holes exceed 400 ft. in depth, and about 100 ft. of this is in glacial drift which is easy to penetrate. The deepest hole is 1023 ft. Because of the steep inclination of the strata and the narrowness of the orebodies, many angle holes have been drilled, mostly at 60' to 70" from the horizontal and against the dip of the formation. Angle holes are most advisable. If after initial drilling the beds are of shallow dip, vertical holes or holes of any angle can be used. The total cost of drilling a property is much greater if only vertical holes are used because more holes must be drilled to obtain the requisite information than when angle holes are used. Many tests for variation in angularity of a finished hole have seldom shown more than 2'; therefore, such tests may with safety be abandoned. Because the orebodies are generally about 100 ft. wide and cross a 40-acre tract at a slight angle, and as the dips are usually about 70"