Recent Developments in the Use of Electricity in Mines

Up until a few years ago most of the electrical equipment used in the mines of this country was developed for industrial purposes and was adapted for use in mines by slight modifications. It became apparent, however, that mining conditions differed widely from most industrial applications and it became necessary to design and develop apparatus, particularly suited for use under mining conditions. Most of the electrical apparatus used in mines today, however, does not owe its success entirely to mining development, but in many cases developments in other branches have been taken and improved upon and modified to meet mining conditions. Power Plant: In the earlier days the power plant for the production of electric power usually consisted of fairly small belt driven direct current generators operated from reciprocating non-condensing steam engines. Today where possible the mines purchase power from central stations and where not possible it is ususally produced from turbine driven plants using non-condensing turbines for the smaller plants and condensing turbines for the larger plants. The bad water conditions at many of the coal mines in this country is, responsible in a large measure for the high cost of upkeep and repairs in isolated power plants. This feature with the type of labor available makes it difficult to operate an isolated plant condensing except in the larger mines where water conditions are good and the apparatus can be taken care of. The geared turbine is a particularly simple and rugged piece of apparatus and requires very little attention over long periods of time. Hoists: The first electric hoists to be installed used various types of motors designed for railway or industrial purposes, and the control furnished was far from satisfactory. Today most of the mine hoist motors are of the alternating current type, especially designed for hoisting service. The control for motors of 200 H. P. or over is usually of the magnetic of liquid rheostat type, and as built today will operate over fairly long periods with a very moderate cost of up-keep. Hoists of 1000 H. P. or larger are usually of the direct current type using field control and receiving power from a flywheel or synchronous M. G. set. Hoists of this type have made remarkable records in regard to continuity of operation and low cost of up-keep. Where high speed operation is desired in either coal or metal mines, the D. C. equipment using field control and a separate M. G. set to supply power to the hoist motor is not only the safest and most economical but in many cases is the only type of equipment capable of satisfactorily obtaining the output required. A number of improvements have been brought out with the field control scheme in connection with the acceleration, retardation, overfeed and overwind of the hoist. With these new developments the hoist operator can no longer abuse the hoist by improper manipulation of the control handle. Until a few years ago the matter of safety devices was not given much consideration when installing hoisting equipment. At the present time the safety devices are considered one of the most important items in connection