Preservative Treatment of Mine Timber at Primero Mine

The Primero mine, operated by the Colorado Fuel & Iron Company, is located 17 miles west of Trinidad, Colorado, in Las Animas County. Unusually bad roof conditions, along with heavy side pressure and other conditions causing rapid decay of timbers, all combine to create a very serious timbering problem. The height of the coal averages six feet six inches. It is a heavy coking coal and has a tendency to become easily crushed and broken down in the seam. The seam lies about 35 feet below the sandstone and the intervening formation is composed of loose shaly rock, and as the coal is extracted, the air slackens this rock to such an extent that within 24 hours, roof falls varying from five to fifteen feet in height are likely to occur. Under these conditions it is necessary to use cross bar sets in both rooms and entries, and they must be spaced no further apart than three and one-half foot centers, and be maintained within a distance of three feet of the face. Rooms are spaced on fifty footcenters, and cannot with safety be driven to exceed 14 feet in width, and 200 feet in length. The large pillar must be maintained to protect from side pressure, and the rooms must be driven up and retreated with as quickly as possible to avoid the squeeze caused by the intense side and roof pressure. Best results in extraction have been obtained by driving rooms for only a distance of 150 feet. Under these circumstances, it is readily seen that timbers of small diameters cannot be utilized in timbering any development work of a permanent nature. Entries are driven nine feet wide, and special peeled piling with an average diameter of 12 inches are most commonly used. It, is necessary to use lagging between each set of crossbars . Conditions such as these necessitated an immense expenditure for mine timber. In addition to ordinary seven and eight foot props, we used a yearly average of 65,000 feet of heavy peeled piling, averaging in diameter from 10 inches to 12 inches. Annual expenditures for timber of all classes was in excess of $60,000.00. Timber costs per ton averaged around 29 cents. In view of these exceptionally severe timber conditions at Primero, the company, in 1920, had a survey made with a view of providing some remedy to this problem. A comparison of the life of main entry timber at other bituminous mines was made, and an average life of four years was established. The actual data collected at Primero indicated an average of less than two years in the manway or "return" airways, and up to five years on the haulageways or "intake" airways. While some of this timber will stand up for a much longer period than this, a close inspection will reveal in most cases that its period of usefulness is spent. It is very essential when discussing the life of timber, especially that used on, main haulageways and aircourses, that a distinction be made between the point of service, that is, the point where it is sound, serviceable and able to carry weight, and the point of breakdown or failure, where it is no longer sound and able to carry weight. In figuring the life of timber, the point of service only should be considered as timber will frequently stand for a considerable length of time when it is entirely decayed and unserviceable. The larger part of the timber used for our permanent work was Alpine Fir, or what is locally termed Red Spruce, and the supply of this I is gradually becoming depleted and has to be obtained at a point so distant