Papers - Use of Pulverized Coal as Fuel for Open-hearth Furnaces Melting Steel for Castings (T.P. 1119, with discussion)

The American Institute of Mining, Metallurgical, and Petroleum Engineers
Joseph P. Kittredge
Organization:
The American Institute of Mining, Metallurgical, and Petroleum Engineers
Pages:
10
File Size:
384 KB
Publication Date:
Jan 1, 1940

Abstract

At the time this matter first came up in 1912, the National Malleable and Steel Castings Co. had seven basic-bottom open-hearth furnaces in its plant at Sharon, Fa., using fuel oil, then costing about 2½¢ per gallon. The fuel was satisfactory but its cost fluctuated widely, therefore the use of pulverized coal, which had been successful in the cement industry and in some metallurgical furnaces, was suggested. After a thorough investigation, and an actual trial on one of the open-hearth furnaces, to be certain that the siliceous ash in the coal would not seriously affect the basic slags, the management of this company approved its adoption and a complete installation was started. The conclusion had been reached that the success of the operation depended on pulverizing the coal to greater fineness than had thus far been accomplished, and all equipment was chosen with this in mind. A coal drier was deemed essential, and one of ample capacity and efficiency was selected, which has done all that was expected of it, working without failure and with very small maintenance cost, and is still in operation. Pulverizers The company demanded a pulverization of at least 90 per cent through a 240-mesh screen, with consistent results, and a machine was chosen that was grinding other materials than coal to the fineness desired. The control of fineness was obtained through a vacuum separator, and was governed by the size of the separator and the number and construction of the valves necessary to expand and direct the air current. These valves can be set to obtain any degree of fineness desired, and the result is consistent. Two machines were installed, each capable of producing 2½ tons per hour, 95 per cent through 240 mesh. These machines have done everything expected of them, have run continuously, and are still in operation. An examination of some of our pulverized coal by elutriation and microscopic measurement disclosed that a 1-lb. lump of bituminous coal,
Citation

APA: Joseph P. Kittredge  (1940)  Papers - Use of Pulverized Coal as Fuel for Open-hearth Furnaces Melting Steel for Castings (T.P. 1119, with discussion)

MLA: Joseph P. Kittredge Papers - Use of Pulverized Coal as Fuel for Open-hearth Furnaces Melting Steel for Castings (T.P. 1119, with discussion). The American Institute of Mining, Metallurgical, and Petroleum Engineers, 1940.

Export
Purchase this Article for $25.00

Create a Guest account to purchase this file
- or -
Log in to your existing Guest account