Papers - Hydraulics of Flowing Wells - Mid-Continent Practices in Handling Flowing Wells (With Discussion)

Common practice in the Mid-Continent until recently was to prolong the natural flow of oil wells as long as possible by agitation, and then swab for a short period until the well was put on the pump. Comparatively recently the gas-lift has superseded the swabbing and agitating period and in some cases encroached on the natural flowing life, particularly where it was evident that the potential oil capacity of the well was greater than the gas supply, or lifting medium. The majority of wells are finished with either 6¼, 65/8 or 8¼-in. casing and connected to a separator through a flow line which is usually 65/8 in. The flow line is generally designed to eliminate sharp turns and has reduced the gas-oil ratio and therefore increased the efficiency in a good many instances. Until recently all wells were allowed to flow without restriction against the possible trap pressure until it was deemed advisable to put them on gas-lift. This resulted in a fairly efficient flow during the early life of the well if the well was rather large but was usually inefficient in small wells and in the later flowing life of large wells, on account of the large area in the casing and therefore excessive slippage. Recently, considerable effort has been made to increase the efficiency of small flowing wells by running tubing to eliminate as much slippage as possible. With large wells there is a considerable trend toward back-pressuring, or beaning to find out whether it is possible to reduce the gas-oil ratios and increase the flowing life. The greater number of fields that have been back-pressured have been produced in that manner through necessity, either to restrict production for proration purposes or, in fields producing by hydraulic pressure, to reduce water encroaching. The recent Cromwell sand development in Little River is an example where both back-pressuring by means of high-pressure traps and beans and flowing through tubing were used to conserve gas, reduce the high gas-oil ratio and prolong the flowing life. It