Longwall Coal Mining

MR. PRESIDENT AND CO-WORKERS IN THE COAL INDUSTRY: I was requested by our president to prepare a paper on Longwall Coal Mining, to be read before this honorable organization. There are three general systems of Longwall, Longwall advancing and Longwall retreating, and the Nottingham system which is worked in England and South Wales. In Fremont county, where I am employed, the Colorado Fuel and Iron Company are working their mines on the advancing system. The face is started generally from the bottom of the shaft or other mine opening, or, at the outside of the pillar left to support the shaft or slope-bottom and advances toward the boundary of coal area. As the roads in this system are maintained by pack walls, it is sometimes called gob-roads system, and by these means the mine is opened up rapidly and consequently early returns are secured from the capital invested. By this method, there is no expense for narrow work, and a minimum amount of timbering of the roads is required. Now what I call ideal Longwall work is where there is about eight inches of dirt mining-and four and one-half feet of coal, .and when the entries and rooms will gob themselves, so that there will be no rock or dirt to haul out to the surface. But this is not the case in the mine I am in charge of. The entries and rooms will not gob themselves, therefor we have to haul the rock and dirt to the surface, which runs up the cost of production. Now the ideal roof in Longwall is composed of tough elastic and pliable strata that yield gradually by bending when the coal is removed, and throwing a sufficient weight or roof pressure on the coal face to break the coal when the same has been mined or undercut. Timbering should be done systematically, the coal well spragged before the miner starts to undermine the coal. Cogs or cribs are alright in their place, but I am not a believer in crib in Longwall working because they are too strong for the roof and do not leave the roof to squeeze .down gradually and break the roof around the crib. Longwall work requires particular skill on the part of the miner, and a familiarity with the conditions affecting room and pillar work, and a good room and pillar mail may not be successful in. Longwall work. A good Longwall miner realizes more than any one else the importance of being regularly at his place every working day. A day lost causes his place to fall behind the others which makes his work harder, and his daily output is further reduced by the amount of small coal that is liable to result from the excessive pressure where the face falls behind. The bad results are also felt by the miner working on each side of such place, as the roof pressure is often insufficient and the coal does not break as well as when the face is kept in a uniform line.