Introduction of Down-Reaming in Australia

Since the introduction of raiseboring 30 years ago there have been many operational and mechanical design improvements in the raiseboring machine, its reamers and associated cutters. These have now made the technology of raiseboring a routine and practical operation within the underground mining world. Over the last decade these advances have been aided by the introduction of robust automation packages which have allowed unattended drilling and reaming, real time performance monitoring and enhancement and the rapid diagnostic investigation of mechanical and electrical abnormalities. The constraint to higher raiseboring performance is now the drill string. However when it comes to a cost-effective solution of applying the high drill string torque and tension necessary for the next step change in performance, designers have æhit the wallÆ. Whilst carbon fiber reinforced plastic composites with abrasive resistant sheaths may offer a solution, the limit of conventional steel, drill string technology has been reached. This limit to advancement is however based on the drill string being in tension and alternative solutions may exist by literally turning the raiseboring paradigm on its head. This paper describes the story of a small Australian company engaged in the design and manufacture of mechanical excavation machines, two Australian raiseboring contractors and three Australian mines going against tradition and pushing down rather than pulling up.