Discussion Of Graham Bright's Paper

A great many questions were asked Mr. Bright, and Mr. Bright's opinion was given on a number of subjects. He spoke at length on spring suspension of locomotives, bringing out the necessity for better spring suspension due to heavier weights and higher speeds now developed. The subject of dynamic braking was brought up, and the opinion of the engineers present was that dynamic braking was not a desirable feature except where heavy, long, adverse grade is encountered. Mr. Goddard and Mr. Bright had a spirited discussion regarding ball bearings, bringing out the opinion of the meeting that ball bearings in motors are preferable to sleeve bearings, and the few failures so far encountered are due to improper application or insufficient size of bearing. Mr. Shubart brought up the question of locomotive speed, mentioning some high speed work on main haulage, also an interesting experiment in a large Eastern mine where very slow speed, 3 1/2 miles per hour, gathering locomotives were substituted for the high speed gathering locomotives with an increase in cars gathered and a material decrease in derailment and accident. Mr. Bright mentioned the improvement in gathering reels, and Mr. Shubart mentioned the safety in the use of the concentric cable in direct current, using the outer wire as the ground wire, so that in case of accident to the cable, the ground wire acted as a protector to the live wire, materially decreasing the danger of sparking. Mr. H. I. Smith of the Bureau of Mines brought up the question of explosion proof construction, and Mr.. Bright and. Mr. Shubart explained the construction adopted by two of the larger manufacturers. Experiment has shown that the force of explosion in motors due to gas does not exceed 150 pounds per square inch. All forms of screen or baffles have proven an actual source of danger, due to the collection of dust, usually soaked in oil, forming an active means of propagating flame, together with the fact that all these appendages are frequently left off when the motors are repaired. Modern construction eliminates all openings, screens, devices for stopping or extinguishing flame. The motor is made entirely enclosed, practically air tight, all joints are ground and all openings necessary for access and attention are closed by bolted plates. The case is made stout enough to withstand any interior explosions, and ample ribbing is provided for heat dissipation. Mr. Bright was asked regarding the use of contactor control. He replied that his company is now recommending contactor controls for series and parallel starting on all locomotives of 13 tons and over, and particularly on the tandem units that are now becoming popular in coal mining work. The question of dynamic braking and reversing was brought up and Mr. Bright explained that this made a very complicated contactor installation but they had