Dewatering of Rouse Mine

The Rouse Mine, belonging to the Colorado Fuel & Iron Company, earlier known as the Santa Clara Mine, is located at Rouse, Huerfano County, Colorado. Operations at this property started about the year 1899, after the old Rouse mine had been drowned out by a large flow of water coming from the strata underlying the Cameron seam. The present new Rouse mine was opened by a slope on what is familiarly known as the Walsen seam in the Walsenburg district. This slope has an average grade of 12 per cent bearing approximately, south 45 degrees west, and having at the present time a total length of 6300 feet. This seam has an average thickness at that property of five and one-half feet; however, there are sections of the mine where the thickness is from seven to eight feet. The mine has been developed. since the time it was opened on what is known as the Room and Pillar system ; water level entries have been driven right and left off the slope, and in some cases the rooms are driven directly up the pitch; and in other cases entries have been driven with rooms turned on water level courses. The first flow of water of which we have ally record was encountered in 1901 in what was called the "Second West Entry." This flow, however, was small, and did not require the installation of any large pump unit. From 1901 up until 1909 the flow increased normally as the field was developed. In January, 1909, the first large inflow occurred, coming from a break in the seventh west entry, making a total flow at that time of about 500 gallons per minute. This necessitated putting in larger pumps, and the first pump to be installed of the centrifugal type was a 600 gallon Worthington. By the year 1911 the water had increased, due to additional development, until it was found necessary to install an additional 600 gallon Worthington centrifugal type pump. In December, 1912, a break occurred in the eighth west entry, between the fourth and sixth cross entries, making 2000 gallons per minute. This flow decreased after a period of three weeks some 500 gallons, but on account of the quantity of water then being handled at the mine, and in view of the fact that we needed some reserve pumping equipment to take care of these flows, and additional 600-gallon Worthington centrifugal type pump was installed in June, 1913. An the latter part of 1914 a 250 gallon Reese roturbo was installed to take care of the water, which was being made in the lower workings of the slope. We found after the installation of the centrifugal pumps that the water decreased to a certain degree in the uppermost workings. This led us to believe that the field was being drained, more or less, and the head reduced ; however, our ideas in regard to this were again upset in December, 1915, when we encountered a flow in room 6 off the first cross entry on the ninth east entry. This flow was not as large as previous flows had been, but made 200 gallons per minute.