Coal Mine Explosions

Safety Measures Employed at the Dawson Mines Preventive measures for eliminating and localizing explosions is a subject of special interest to Coal Mining operators at the present time. I shall endeavor in this paper to present the practical methods which have been developed at the mines of the Stag Canon Branch of the Phelps-Dodge Corporation, Dawson, New Mexico. Adobe Dusting Adobe is used for practically all dusting on the main haulage roads. It is obtainable in sufficient quantities adjacent to the mines. Loaded into railroad cars by a clam-shell loading crane, and transferred to the mine pit cars at the nearest available point, it is readily distributed along the motor roads by means of the mine locomotives. Of first consideration for adobe dusting is the preparation of the roadway. It is essential that all loose coal and dust be removed, at least to a depth of three or four inches below the top of the rails. The adobe, in a more or less moist condition is unloaded by hand from the pit cars and stored along the previously prepared roadway, to be later scattered to a depth of several inches over the floor, and over the ribs and roof such as is possible by the use of a shovel. The adobe soon loses its moisture and becomes pulverized. Due to the disturbance caused by passing motor trips, men and animals, the dust is effectively scattered along the ribs and roof of the roads. The velocity of the intake air aids materially in sustaining the suspension of this inert matter. Another scheme for distributing the fine dust in use is to chain the top of a pine tree to the rear of the trips, both empty and loaded. Dragging it along the motor roads stirs up the dust and aided by the intake air it is carried for long distances into the workings. The adobe is continually loosened and raked, all rock, coal, etc., being collected in piles and later loaded out in pit cars. One man is employed for each six thousand feet of entry. Dusting Main Return Air-Courses The air-courses are first thoroughly cleaned. All the loose coal and rock is loaded out, the ribs and roof washed down several times. Every five or six hundred feet, the stoppings between the main and return entries are broken through and small doors installed. Blowers are used to force the fine dust into the return air-courses through these openings. Thus suspended the dust travels a considerable distance before it is deposited on the floor, ribs and roof. The material used is chiefly adobe, sun dried, and screened on the outside. A two ton car load of this dust will cover several hundred feet of airway as very little loss occurs, often depositing from 2 to 6 pounds per running foot of entry. Methods of Insertion Blowers are used to force the dust into the main returns. One unit consists of a small Buffalo blower mounted on a truck with a two H. P. motor. A six-inch pipe is attached to the blower and runs the full length of the truck with a projection over the end. A hopper is built over the pipe and connected. Stove pipe or canvas tubing is led from the pipe through door in stopping. When the blower is started dust is fed into the