Backed -up Mills for Continuous Rolling (9074a620-ca34-45ad-8565-fdf285a1e900)

THE history of the development of the strip in- dustry, mentioned in this paper, was covered in considerable detail by Stephen Badlam in his paper presented. before the American Iron and Steel Institute at its meeting in New York last October. The description of progress in rolling strip there out-lined will be found good reading by anyone interested in the subject. Quoting from Mr. Badlam's paper, "For practically thirty years, we find no record of the use of the backing-roll principle, until in 1916 the Lukens Steel Co., Coatesville, Pa., put in a 206-in. plate mill of the four-high type. This was a reversing mill with two 32-in. working rolls and two 50-in. backing rolls and is today making the widest and heaviest plate made anywhere in the world." The functioning of this mill, though rolling hot plate, is, on account of the extreme width and thinness of plate rolled, quite comparable to the rolling of wide strip either hot or cold and was a considerable factor in demonstrating the marked advantages available with the four-high or backing-roll mill for thin accurate rolling. As the writer has brought out, a demand for a product, the rolling of which required the character-istics of the backing-roll mill, was broached by the In-ternational Nickel Co. This resulted in an inquiry of March, 1924, for the building of a mill capable of cold-rolling wide nickel and monel metal sheets or strip, as mentioned. It may be of some interest to note, that whereas the .six-roll cluster mill with plain bearings was built for this installation, the mill designed by the United En-gineering and Foundry Co. for this inquiry was of the four-high type with roller bearings on the backing-roll necks, being essentially the same design as the four-high roller-bearing mill built in 1925 for the Rome Brass & Copper Co. This Rome mill, to quote again from Mr. Badlam's paper, "fulfilled every requirement, and was the model on which succeeding mills of this type were built."