Application of Automated Miner- Bolters in Coal Mine Development

Miner-bolters, which combine mining and bolting functions into a single machine, are being developed by the US Department of Energy to improve production and productivity in coal mining operations. The authors have been studying possible production gains from the use of the Joy automated miner-bolter (AMB) in mine development using the computer simulation model "UGMHS" developed by the Pennsylvania State University. In a recent paper (Chugh, Campbell, and Parkinson, 1979) the authors discussed justification for the development of miner- bolter machines, assumptions and analytical procedures used in computer simulation, cutting, and bolting cycle times for an AMB, and production potential of AMB in four and five entry mine development sections. The effects of available operating time, haulage capacity, bolt installation time, and flush and staggered entry layouts on production potential of AMB were also discussed. In all cases, the production potential of AMB was compared to a full face continuous miner and an independent dual-boom roof bolter operating in a similar mine layout. Present Study In this study, the production potential of the Joy AMB in three and six entry layouts is presented. A three entry mine layout represents development entries in a longwall panel. A six entry layout represents development of main and submain entries in longwall mine development. Flush and staggered entries were considered in both layouts. The assumptions and analytical procedures used in this study were similar to those in the earlier study and are not presented in this paper. Only the results of the studies are presented here.