Protecting Underground Coal Miners From Rib Falls

Gauna, Michael
Organization: International Conference on Ground Control in Mining
Pages: 9
Publication Date: Jan 1, 2011
In 2010, the number of fatal rib falls in U.S. underground coal mines exceeded fatal roof falls for the first time ever. While recent trends have seen roof fall fatalities reduced by about 62% since the 1990s (from an average of 9.6 per year in the 1990s to 3.6 per year during the last five years), the incidence of rib fall fatalities has remained approximately constant (about 1.5 per year). In addition, injury incidents associated with pillar rib failure have been steady at approximately 100 per year. The persistence of rib fall injuries, underlined by the recent increase in rib fall fatalities, has led to this investigation of the coal rib failure parameters and methods available to mitigate rib failure in U.S. underground coal mines A detailed study of the 21 fatal rib fall incidents that have occurred since 1995 (excluding coal burst incidents) indicates that the two most important risk factors are the mining height and the depth of cover. The depth of cover was 700 ft (213 m) or greater in 81% of the fatalities, and the mining height was at or exceeded 7 ft (2 m) in every instance but one. Other risk factors included multiple seam interactions, rock partings in the seam, and retreat mining. The accident history reveals that joints or slickenside features within the rib increase the hazard. Approximately threequarters of the rib fatality victims were roof bolting machine operators and continuous mining machine operators. This paper includes a brief overview of techniques for rib control; including bolts, standing support, bent steel straps, and rib strapping. The available mining equipment features for installing rib support and protecting operators from rib falls are also discussed. A proactive approach to rib control using available technologies will lower the risk to miners and is an endeavor that must be pursued to reduce rib fall accidents.
Full Article Download:
(2002 kb)

Additional chapters/articles from the SME-ICGCM book 30th International Conference on Ground Control in Mining

A Study on Geotechnical Risks in Interaction Between Open-Pi
Think Like a Rock
Mapping and Application of Roof Joint Patterns for Ground Co
The Autowarning Telltale: A New Safety Monitoring Device for
Recent Innovations for Slope Development
Analysis of Roof Falls at and Recommendation of Roof Control
The Introduction of Uk Rockbolting Technology into Coal Mine
A Pipeliner's Perspective on Longwall Mining
Why Dead Load Suspension Design for Roadway Roof Support Is
Investigation Into Abnormal Surface Subsidence Above a Longw
Protecting Underground Coal Miners From Rib Falls
MSHA Technical Review of Proposed Mine Designs for U.S.Under
Prediction of Roof Fall Rate in Coal Mines Using Fuzzy Logic
Surface Subsidence Velocity of Fully-Mechanized Thick Seam T
Engineering Geophysics - Mine Subsidence Risk Assessment Stu
A Retrospective on LaModel (Or Dr. Heasley?s Wild Ride)
Safe Pillar Extraction Practice - Some Geotechnical Principl
Case Study of Roof Behaviour and Conditions for Longwall Fac
Early Warning of Longwall Weighting Events and Roof Cavities
Streams and Longwall Coal Mining Subsidence: A Pennsylvania
Surface Structures Impacted By Subsidence From Pennsylvania
GIS Supported Evaluation of Surface Level Impacts Due to Aba
Development and Application of Impact-Resistant Lagging for
Detection and Monitoring of Surface Subsidence Associated wi
Applications of ARMPS (Version 6) to Practical Pillar Design
The Duncan Method of Partial Pillar Extraction at Tasman Min
The Duncan Method of Partial Pillar Extraction at Tasman Min
Geotechnical Considerations for Longwall Top Coal Caving at
Assessment of the Dynamic Loads Effect on Underground Mines
Designing Shotcrete As Primary Support in Tunnels
The Influence of Interface Friction and W/H Ratio on the Vio
Gateroad Support in the Czech and Polish Coal Mining Industr
Study on Eco-Friendly Underground Mining System for Ultra-Th
Ground Control Technology for Mass Exploitation of Coal Depo
The Initial Performance of Commonly Used Primary Support on
Application of Stress, Geologic, and Support Design System (
A Retrospective Assessment of Ground Control Research and Ap
Calculating the Mining-Induced Horizontal Deformation Indice
Understanding the Causes of Roof Control Problems on a Longw
The Technical Progress and Problems to Be Solved of Thick Co
Topography and Coal Seam Initial Stress Estimation: a Sensit
The Effects of Longwall Coal Mining on the Hydrogeology of S
Application of Yield-Lok Bolt for Bursting and Convergence G
Research on Mine Pessure Behaviors and Overlying Strata Move
Preventing Roof Fall Accidents - An Operation's Approac
Roof Bolting for Long-Term Entries in Underground Coal Mines
Numerical Modeling of the Pillar Confinement with Backfillin