If you have access to OneMine as part of a member benefit, log in through your member association website for a seamless user experience.
|Quinsam Coal Mine located in Vancouver Island, BC, Canada is mining the No. 1 coal seam at the 2 North/3 North mine and the No. 3 coal seam at 4 South Mine. This paper describes its geology and structure, mining and processing, development and depillaring practices as well as methods of roof supports under various geological conditions.|
Additional chapters/articles from the SME-ICGCM book 24th International Conference on Ground Control in Mining (ICGCM) 24th
|Keynote Address at the 23rd International Conference on Grou||Analysis and Design of Rib Support (ADRS) a Rib Support Desi||Evaluation of the Impact of Standing Support on Ground Behav||Half a Career Trying to Understand Why the Roof Along the Lo||Forecasting Roof Falls with Monitoring Technologies - A Look||Analysis of Seismic Source Parameters of Roof Falls in Time||A System to Provide Early Warning on Impending Goaf||Outcomes of the Landmark Longwall Automation Project with Re||Application of Phenolic Foam in Longwall Mining||Multiple Seam Mining Interactions: Case Histories from the H||Analysis of Entry Stability Associated with Multi-seam Minin||Failure Mechanics of Multiple Seam Mining Interactions||Engineering Classification of Ultra-close Multiple Seam Roof||Definition of Ultra-close Multiple-seams and its Ground Pres||Depillaring and Roof Bolting Practices at Quinsam Coal Mine||Seam Structure - An Important Criterion for Coal Pillar Desi||Mitigating Longwall Subsidence Effects on a Large Industrial||Impacts of Longwall Mining on Hydrology, Soil Moisture, and||Basics on the Dimensioning and the Extraction of Shaft Safet||Modeling the Arc-effect of a Coal Mine Roof||Recent Advances in Numerical Simulation of Cutter Roof Failu||Test Method for Assessing Water Degradation Potential of Coa||Geotechnical Strata Characterisation Using Geophysical Boreh||A Method for Quantitative Void/Fracture Detection and Estima||Implication of Highly Anisotropic Horizontal Stresses on Ent||Ground Control of a Mine Stope in Weak Rocks Subjected to Hi||Analysis of Highwall Mining Stability - The Effect of Multip||Highwall Mining in a Multiple-seam, Western United States Se||The Slope Stability Assessment in the Wall Overlooking the S||Numerical Modeling as a Tool to Predict Pillar Condition and||Development and Testing of a New Roof Prop||Stability Mapping System||Using Foaming Grout to Stabilize a Ventilation Raise in Very||Roof Control and Roadway Support Design in the #9 Coal Seam,||Non-confirmation Mathematics for Wall Rock Classification fo||The Influence of the First Layer Thickness of Immediate Roof||Studies on Distribution Pattern of and Methane Migration Mec||Development of a New Roof Bolt Technology to Improve Gate- R||Improved Pull out Strength of Fully Grouted Roof Bolts throu||Experimental and Numerical Methodology Assessment of Load Tr||An Investigation into the Support Systems in South African C||Investigation of Fully Grouted Roof Bolts Installed Under In||Development of the Laboratory Short Encapsulation Pull Test||A Resin Quality Testing Procedure for Collieries||Determination of Load Transfer Characteristics of Gloved Res||Fully Grouted Torque Tension Bolts Successfully Support Pitt||Shear Bond Characteristics in Grouted Cable Bolts||Overcoring Techniques to Assess in Situ Corrosion of Galvani||Development of a Laboratory Facility for Testing Shear Perfo||Mechanical Response of Split-Set Rock Bolts in Squeezing Gro||Mechanisms of Rib Sloughing and Methods of Controlling Thick||Supporting Method of the Bolted Strata in Large Deformation||Assessment of Ground Conditions Near a Mine Portal Using Gro||Detection of Abandoned Mines and Air Passages/Burning Center||Detecting Abandoned Coal Mine Entries by High Resolution Ear|