If you have access to OneMine as part of a member benefit, log in through your member association website for a seamless user experience.
|This paper describes geomechanical criteria employed by Consol Energy for selecting mine-specific longwall face supports in the past decade. The criteria include immediate and main roof rock characteristics, floor rock characteristics, critical tip-to-face distance and shield operating range. Detailed roof rock properties from high-density core holes as well as in-mine scope holes are used to evaluate the set load density and shield stiffness required to control the immediate roof and the yield load density required to absorb the load density developed from main roof weighting. Detailed floor rock properties from core holes and in-mine floor bearing capacity tests are used to specify the maximum peak toe pressure as calculated by the Jackson method. The critical tip-to-face distance is evaluated based on the immediate roof rock strength, layering and thickness. The shield operating range is evaluated based on main bench thickness, the presence of thick draw slate, the potential of minor roof falls at the face and transportation restriction. Three case examples representing three different geologic conditions are presented to illustrate the successful application of these geomechanical criteria for selecting longwall face supports within Consol Energy in the past decade.|
Additional chapters/articles from the SME-ICGCM book 23rd International Conference on Ground Control in Mining (ICGCM) 23rd
|Geomechanical Criteria of Longwall Face Support Selection at||Rock Fracture, Caving and Interaction of Face Supports Under||Effect of the Approaching Longwall Faces on Barrier and Entr||Computer Simulation of Ground Behaviour and Rock Bolt Intera||lnterpanel Barriers for Deep Western U.S. Longwall Mining||Application of Yieldable and Cuttable Pump Crib in Longwall||Field Testing of a Real Time Roof Mapping Drilling Display S||Problems in "Void" Detection in Coal Mine Water Hazards||Violent Coal Pillar Collapse -A Case Study||Stooping Low Safety Factor Pillars at Goedehoop Colliery - 1||Laboratory Strength Testing of Coal from Selected Illinois S||Downhole Overcoring Stress Measurement at a Western Undergro||Effect of In Situ Stresses on the Stability of Coal Mine Dev||SOMA: A New Method to Calculate the Operative Stress Field:||Numerical Modeling for Increased Understanding of the Behavi||Evaluation of Rockburst Hazard from Core Testing||Investigation of Electromagnetic Emissions in a Deep Undergr||Development and Application of Geotechnical and Rockmechanic||Laboratory Testing of Rib Straps||The New Two-Dimension LaModel Program||Risk Assessment: Multiseam - Single Seam Mining||A Method To Determine Expander Spacing For Steel Pipelines I||A Case Study Of Abandoned Mine Subsidence At Dominion, Nova||Spatial Trends In Rock Strength - Can They Be Determined Fro||Development And Demonstration Of An Alternate Mining Geometr||Evaluation Of Polyurethane Injection For Beltway Roof Stabil||Application Of Ground Penetrating Radar To Evaluate The Exte||A Risk Assessment Tool For Open Cast Mining In South Africa||Analysis Of Practical Ground Control Issues In Highwall Mini||Preventing Falls Of Ground In Coal Mines With Exceptionally||Geo-Mechanical Property And Failures Of Weak Roof Shales In||Eclipse System Bolting In The Illinois Basin||Variation In The Load Transfer Of Fully Encapsulated Rockbol||Bolt Load Changes During Initial Face Advance And Cross-Cut||Coal Mine Primary Support Selection: Tension Versus Non Tens||Improving Stope Support At Modikwa Platinum Mine||3D FEM Simulation For Fully Grouted Bolts||An Investigation Into The Effectiveness Of Support Systems C||Hydraulic Prestressing Units: An Innovation In Roof Support||Improving Roof Truss Performance||Coal Combustion Byproducts-Based Artificial Mine Supports -||The Influence Of Horizontal Stress On Pillar Design And Mine||Investigation Of Pillar-Roof Contact Failure In Northern App||Mapping Hazards With Microseismic Technology To Anticipate R||Practical Detection Of Underground Mine Roof Failure||Heat-Imaging Experimental Study Of Reducing Local Gas Accumu||Microcirculation Theory Analysis Of Spontaneous Combustion O|