Rockbolted Support of Retreat Longwall Gateroads at 1000m Depth: A Case History

Brandt, Karl
Organization: International Conference on Ground Control in Mining
Pages: 10
Publication Date: Jan 1, 2002
Longwall panel 580 has recently been retreated in the Zollverein 1/2 seam at a depth of approximately 1000m at Auguste Victoria mine with rectangular rockbolted roadways used for both the maingate and tailgate. Although Auguste Victoria mine has been increasingly using rockbolted support since the mid 1990's. this has previously been restricted to tailgates for single use. This panel represents the first use of a rectangular rockbolted roadway as a maingate at Auguste Victoria mine. As such, it represents a significant change in support strategy. As part of the strategy numerical modelling was used to examine expected behaviour of rockbolted roadways at the site, stress changes during face retreat, the feasibility of adopting rockbolted support for the maingate and the reinforcement pattern required. Monitoring instrumentation was installed in both gates to confirm that the support systems were performing satisfactorily as the gates were driven and as the face was retreated. Although the panel is isolated from others in the Zollverein 1/2 seam, markedly different roadway conditions have been experienced in the two gate roads. Favourable conditions were obtained in the maingate, but particularly difficult conditions were encountered in the tailgate. Previous work for the mine had examined interaction with old workings in other seams and shown a vertical stress of 28MPa for the maingate and up to 45MPa for the tailgate. The values from the earlier work were used in the modelling work described, which showed contrasting results given the different stresses. The difference between the gates can be attributed to the interaction. The paper describes the numerical modelling work, the reinforcement systems adopted, the monitoring results, the interaction effects and the comparison between expectations from the numerical modelling results and the conditions actually experienced.
Full Article Download:
(2474 kb)

Additional chapters/articles from the SME-ICGCM book Proceedings 21st International Conference on Ground Control in Mining

Pre-Driven Experimental Longwall Recovery Room Under Weak Ro
Longwall Mining-Induced Abutment Loads and Their Impacts on
Influence of Structural Stress Concentration and Structural
The NIOSH Shield Hydraulics Inspection and Evaluation of Leg
Study on Top-Coal Loss and the Optimum Drawing Interval of L
Stress Measurements for Safety Decisions in Longwall Coal
Re-Use of Rectangular Bolted Roadways in a Cover Depth > 100
Numerical Modeling of the Gob Loading Mechanism in Longwall
Deep Cover Pillar Extraction in the U.S. Coalfields
Evaluation of Pillar Recovery in Southern West Virginia
A Case History Investigation of Two Coal Bumps in the Southe
A Linear Coal Pillar Strength Formula for South African Coal
Anchorage Pull Testing for Fully Grouted Roof Bolts
Comparison of Some Aspects of Bolting Mechanisms Between Ful
Eclipse System Improves Resin Anchored Rebar Bolting
Design Considerations for Tensioned Bolts
Field Testing of the Fully Grouted Thrust Tensioned Bolts
Improvement in Pre-Tensioning of Strand Bolts in Australian
The Introduction of Roof Bolting to U.S. Underground Coal Mi
Support of Coal Mines in the United Kingdom
The Use of NDT Methods to Determine the Condition of Rockbol
Rockbolted Support of Retreat Longwall Gateroads at 1000m De
Roof Screening: Best Practices and Roof Bolting Machines
Numerical and Physical Modeling as Planning Tools for Rockbo
Stone Mine Design in Highly Fractured Rock
The Importance of Underground Stone Mine Roof Geology
Utilization of Ground-Penetrating Radar to Determine Roof Co
An Examination of the Loyalhanna Limestone's Structural
Highwall Stability in an Open Pit Stone Operation
Overview of Safety Considerations with Highwall Mining Opera
Highwall Monitoring to Combat Rockfall Accidents at Opencast
Seepage and Reinforcement Behavior of Grouting Into Slaking-
Floor Heave in Shallow Room-and-Pillar Mining
Analysis of a Stability Problem in an Underground Coal Mine
Comparison of Acoustic Emission and Stress Measurement Resul
Acoustic Scanner Analysis of Borehole Breakout to Define the
Estimating Rock Strengths Using Drilling Parameters During R
New developments with the coal mine roof rating
Application of geotechnical and geophysical parameters to im
Development of a Risk Rating System for Use in Underground C
Empirical and analytical design of large openings at a propo
Shear Mechanism for Mining-Induced Fractures Applied to Rock
Evaluating Techniques for Monitoring Rock Falls and Slope St
Developments in Sealant Support Systems for Ground Control
Stability Control of Clusters of Deep Openings Around Shaft
The Use of Pneumatic Stowing in Germany Considering Subsiden
A 3-D Semi-Analytical Method for Subsidence Prediction and S
Theory and Technology of Mining Subsidence Control by Grouti
Surface Subsidence Due to the Combined Effects of Undergroun