If you have access to OneMine as part of a member benefit, log in through your member association website for a seamless user experience.
|A room and pillar coal operation in central Pennsylvania was experiencing roof cutters and long running roof falls caused by high horizontal stresses. The roof conditions created hazards for the miners, and caused several production panels to he abandoned prematurely. The mine requested assistance from the National Institute for Occupational Safety and Health (NIOSH) in applying the "advance and relieve" mining to reduce the affects of the horizontal stress during panel development. The "advance and relieve" plan that was developed called for removing a pillar on one side of the panel as it was being advanced, thus creating a cave. The caving then relieved a portion of the horizontal stress across the panel. Because the horizontal stress direction is key to the success of this method, stress mapping as well as mining experience was used to establish the direction of the horizontal stress. Subsequent field measurements provided an estimate of the stress magnitude. Three panels were mined using this technique, and good roof conditions were achieved in all these panels. Instrumentation was used to monitor the stress changes in the roof created by the cave. Stress relief of over 1.000 psi was measured 120 ft from the cave and to depths of 20 ft into the roof. The lateral extent of the stress relief zone across the panels appears to be about 400 to 500 ft. This case history has provided much insight into the practical application of the "advance and relieve" method discussed in this paper.|
Additional chapters/articles from the SME-ICGCM book Proceedings 19th International Conference On Ground Control In Mining
|An Approach To Identifying Geological Properties From Roof B||Field Experience Of Measuring The Acoustic Energy From A Ham||Advancements In Reflective Seismic Tomography For The Locati||Longwall Geomechanics, An Australian Perspective||Moonee Colliery: Renewing The Economic Viability Of A Mine U||Successful Application Of Hydraulic Fracturing To Control Wi||Pillar Mining And Longwalling Below Massive Roof Strata: Geo||High Capacity Tensioned Cable Bolts For Tailgate Support||Single Point And Full Scale Laboratory Testing Of Timber Cho||Optimizing Secondary Roof Support With The NIOSH Support Tec||The Use Of Cribless Tailgates In Longwall Extraction||Five Stress Factors Conducive To Bumps In Utah, USA, Coal Mi||Development Of Stress Measurement Techniques In Bump-Prone C||Coal Mine Seismicity And Bumps: Historical Case Studies And||Multi-Scale Assessment Of Coal And Gas Outbursts Based On Fr||Horizontal Stress: The Root Of All Evil?||Utilizing The ?Advance And Relieve? Method To Reduce Horizon||Regional Horizontal Surface Displacements Due To Mining Bene||Prognosis And Control Of Mining Induced Surface Subsidence A||Prediction Of Subsurface Subsidence For Longwall Mining Oper||Development Of A Statistical Technique For Assessing Sandsto||Evaluation Of Surface Subsidence Potential Along A Pipeline||Roof Monitoring In Limestone Mines-Experience With The Roof||Site Characterization For Planning Underground Stone Mines||Potential Problems Related To Mining Under Or Adjacent To Fl||Mine Planning For Longwall And Pillar Retreat Panels Subject||Optimization Of District-Wide Mine Layout In Multi-Seam Mini||Application Of Bolt Design Criteria At Galatia Mine||The Utilization Of Rockbolting Technology And Monitoring Tec||Rockbolting For Highly Stressed Roadways||Evaluation Of Measurement System For Monitoring The Stabilit||Quality Management For Grouted Rockbolts||Evaluating Anchorage Mechanisms Of Fully Encapsulated Rock B||INSTáL CableOx: A New Tensionable & Corrosion Resistant Cabl||Rock Reinforcement Longevity||Progress In The Development Of A Roof Bolt Design Methodolog||Case Studies Of Progressive Pillar Failure In Two Mines Usin||Jointing Effects On Pillar Strength||Impact Of Vertical Stress On Roadway Conditions At Dartbrook||Stepwise Support Technology For Extremely Soft Rock Roadway||Mobile Roof Supports For Pillar Retreat Mining||Three-Dimensional Simulations Of The Roof Behavior In Coal R||Roof Behavior In South African Coal Room And Pillar Panels||Extended Cut Out Distances In Continuous Miner Sections In S||Roof Control Analysis In North River Mine||Analysis Of The Seam Inclination Effect On Roof Stability||The Application Of Rock Mass Classification Principles To Co||Mining Geotechnical Benchmarking||Using The Point Load Test To Determine The Uniaxial Compress||The Influence Of Water Content On Strength Characteristic Of||Polymer Membrane Liners In Underground Coal Mines - Ground C||Applications Of Cement Grouting Method For Controlling Weak||Analysis Of Safety Aspects And Mining Practices For Effectiv|