If you have access to OneMine as part of a member benefit, log in through your member association website for a seamless user experience.
|Ground control problems at surface mining operations can occur for a variety of reasons. Stress, gravity loading, rock strength, geology, pore pressure, weather effects, underground workings, and many other factors contribute to slope instabilities that range from small rock falls to massive slides of material. While some of these failures can he predicted or controlled by preventive measures, each year many completely unexpected failures occur. Current methods for monitoring generally involve measuring displacements at a few, selected points in and around the suspected area of instability. While most of the displacements along these points will be in a downslope direction, freeze-thaw cycles of water-filled joints, horizontal stresses or pressure, buoyancy in saturated soils, human measurement errors, or other situations can produce deformation in almost any direction, even without any instability in the slope. Determination of which, if any of the observed movements represents a potential hazard is essential.|
Additional chapters/articles from the SME-ICGCM book 17th International Conference on Ground Control in Mining (ICGCM)
|Gateroad Pillar Extraction Experience at Jim Walter Resource||Stability of Backfilled Cross-panel Entries During Longwall||Mining Through In-panel Entries and Full-face Recovery Room||Cutable and Variable Yield Cement Cribbing Successfully Supp||International Experience with Longwall Mining into Pre-drive||Analysis of Geologic and Geotechnical Conditions and Their E||Comparison of Ground Conditions and Ground Control Practices||Application of Microseismic Monitoring to Longwall Geomechan||Control of Hard-to-Collapse Massive Roofs in Longwall Faces||A Study of Periodic Weighting of Longwall Supports||Effects of Panel Mining Sequence and Retreat Direction on th||Controlling Roof Beam Failures From High Horizontal Stresses||Roof Control Under Conditions of Shallow Depth and High Hori||Assessment of Roadway and Yielding-pillar Performance During||Practical Stress Modeling for Mine Planning||The Design of Room and Pillar Mining Systems in the UK||Geotechnical Planning and Development of the BHP Minerals Sa||Coal Pillar Life Prediction in the Vaal Basin, South Africa||An Analytical Approach to Determine Stress Distribution in L||In Situ Strength Testing of Rocks with the Borehole Penetrom||Performance and Safety Considerations of Hydraulic Support S||A Decade of Mobile Roof Support Application in the United St||A Critical Study of Strata Behaviour During Extraction of Pi||Progression of Longwall Gateroad Support as Conditions Chang||Application of the Coal Mine Roof Rating, Derived from Drill||The Effects of Reduced Annulus in Roof Bolting Performance||Laboratory and In Situ Results of a Slip Nut Yielding Rock B||Field Monitoring of Rock Bolting Performance in Weak Roof St||A Case Study of Bolt Performance in a Two-entry Gateroad||Automated Temporary Roof Support Systems: An Update||Safety and Productivity Innovations in Mechanized Bolting||Factors Influencing Intersection Stability in U.S. Coal Mine||Analysis of the Effect of Rate of Extraction on Strain Devel||Analysis of Panel Stability for Post-Mining Slurry Injection||Development of Timedependent Surface Subsidence Over the Tot||Transversely Elasto-Plastic Analysis of Surface Subsidence A||Landslide Occurrence and Causation in Steep Slope Areas of A||Rock Bursting and Seismicity During Ramp Development, Lucky||Advances in Remote Sensing Techniques for Monitoring Rock Fa|