Significant Weighting Events on the Longwalls in the Phalen Colliery

MacDonald, Bob J.
Organization: International Conference on Ground Control in Mining
Pages: 11
Publication Date: Jan 1, 1997
The Cape Breton Development Corporation is a federally owned Crown corporation in Canada that operates two coal mines the Prince and Phalen Colliery in the Province of Nova Scotia. Retreat longwall mining was first introduced to the shallower workings (I 80m) of Prince Colliery in the early 1980's. Phalen Colliery started longwall retreating in 1987 and since that time has extracted twelve panels. In 1993 there had been a total of eight longwalls varying in widths from 140-230m mined in Phalen Colliery that is on the Phalen Seam. Up to this point there were only minor ground control problems on the faces except for one of the earlier longwalls that was mining a split seam. There is some interaction on Phalen workings from remnant structures in the overlying Lingan and No. 26 Collieries which worked the Harbour Seam. Induced abutments loads along pillar edges have been observed and resulted in poor face conditions when mining the Phalen Seam. The ninth panel, 6 East was the first panel to suffer a major roof fall from the First Major Weighting. This was also the first panel to undermine a paleo sandstone river channel named the Lower Sandstone Unit (LSU). For the first time in Phalen's history subsequent longwalls began to experience periodic weighting events. The 6 East panel suffered a number of periodic weightings and on two occasions had to use foam cement to fill the cavities that resulted. On the next east side panel, 7 East, there were numerous periodic weighting events, but interestingly there was no significant First Major Weighting. 7 East was the first 260m wide panel and all others were 230m or less. This longwall was 3,400m long and began producing in December of 1994 and was still cutting coal in May of 1997. There were five significant roof fall events on this panel, three of which required foam cement to fill the cavities. Of these three the interruption to production varied from four days to seven months. There were definite precursors to each of the weightings including: 1) an increase in audible noise (termed bumping) on the face, 2) supports went rapidly into yield, 3) roof convergence increased, 4) water percolated from the face roof strata, and 5) severe spalling of the coal occurred resulting in increased tip to face distance. Longwall face weightings are a result of geomechanical factors and cannot be avoided However, the loss of roof control is a different matter and highly subjective to operational procedures. The causes of weightings, their magnitude and impact on the mining at Phalen have been investigated. The following factors have been identified as relevant to these occurrences. 1. The influence of pillars in the overlying Harbour Seam workings. 2. Location of the LSU relative to the Phalen Seam. 3. Thickness of the LSU. 4. Pressure arch effect from the adjacent gobs. 5. Poor operational practices on the longwall including: a) slow rate of retreat; b) inadequate supply of pump pressure to the hydraulic supports; c) premature yielding of the yield valves; and d) poor face alignment practices. This paper will review the events that took place on the 7 East longwall and show that the Lower Sandstone Unit is the primary cause of the weightings. However, other factors contributed to the loss of roof control and the formation of the roof cavities.
Full Article Download:
(2879 kb)

Additional chapters/articles from the SME-ICGCM book 16th International Conference on Ground Control in Mining (ICGCM)

Longwall Mining-Through the Backfilled In-Panel Entries at C
Performance of Various Standing and Cribless Tailgate Suppor
Measurement of Effects of Interaction and Influence on Mine
Effects of Longwall Mining on Streamflow in the Pittsburgh S
Longwall Surface Subsidence Prediction Through Numerical Mod
Long-term Subsidence Over Longwall Chain Pillar Systems and
Subsidence Prediction Influence Assessment and Damage Contro
Formation of Face Headings Using Stress Relief at Asfordby M
Significant Weighting Events on the Longwalls in the Phalen
Full-face Pressure Monitoring in Medium-Weak Roof Condition
Research on the Interaction Between Roof Strata and Shield S
Roof Instability of Longwall Face at Ikeshima Colliery
Gob Canopy Roof Support for Difficult Natural Conditions
Yielding Cement Roof Supports for Longwall Mining
Management of the Dynamic Phenomena of Rock Pressure in Unde
Continuing Development of Innovative Cable Support Systems
Extending the Limits of Strata Bolting by the Use of Flexibl
Implementation and Evaluation of Roof Bolting in MICARE Mine
New Methods and Technologies of Roofbolting in Australia Coa
New Design Criteria for Roof Bolt Systems
Control Mechanism of a Tensioned Bolt System in the Laminate
A Study of the Performance of Glass Fibre Rock Reinforcement
A Method for the Selection of Rock Support Based on Bolt Loa
Strategies for the Application of Rockbolting Technology to
A Troubleshooting Guide for Roof Support Systems
A Statistical Overview of Retreat Mining of Coal Pillars in
Full-Scale Performance Evaluation of Mobile Roof Supports
Effect of the Interchamber Pi Yield on the Surface Strains i
Salt Pillar Design Equation
Case Study of Conditions Observed During the Removal of a Hi
Case Study of the Effect of Stratigraphic Location on Roof S
Ground Control and the Inundation of the Retsof Mine
Weatherability Test of Rocks for Underground Mines
Shear Strength Characteristics of Soft Rock Joints Based on
Comparison of Pillar Strengths Calculated Using Empirical Eq
Effects of In-seam and Near-seam Conditions and Asymmetric P
Ground Control Worker Safety During Extended Cut Mining
Analysis of Extensometer Data from a Room Widening Experimen
Airbag Support for Ground Control in Thin Seam Coal Mining
Development of a Statistical-Analytical Approach for Assessi
Ground Control Criteria for Coal Reserve Optimization in Mul
Calcium Aluminate Kiders in Hard Rock and Coal Mining
Simplified Pre-and Post-Processing Technique for Performing