In-Situ Coal Strength Determination - Case Studies

Unrug, Kot F.
Organization: International Conference on Ground Control in Mining
Pages: 10
Publication Date: Jan 1, 1995
Strength of coal is one of the governing factors in size determination of mine pillars, and therefore affects the percentage of extraction and thus, utilization of reserves. Coal strength is also important from the subsidence control standpoint, where mine pillars with appropriate safety factors should be designed for long term stability. Determination of coal seam strength has been addressed through the extrapolation of the coal strength obtained from a small number of samples on the whole section of the seam. This procedure often gives unreliable results. Presented in this paper is a method of in-situ strength testing of coal, allowing for a realistic determination of seam strength. Results of a field case study dealing with the coal seam, where samples for the laboratory strength tests could not be obtained due to the dense cleat, are presented. However, in these conditions, the in-situ testing was successful. A comparison of both conventional and the in-situ penetrometer method was carried out. It was found that the penetrometer data not only improve the accuracy of strength determination of the entire seam, but also prove to be much more cost effective than the conventional method on a per test basis.
Full Article Download:
(2187 kb)

Additional chapters/articles from the SME-ICGCM book Proceedings of 14th International Conference on Ground Control in fining

Truss Systems For Longwall Tailgate Support - Update
Cable Support Systems For Longwall Gate Road Stability
Innovative Tailgate Support For Heavy Ground: 11 Left Longwa
Parameters Affecting Resin-Anchored Cable Bolt Performance:
Roof Support Performance In High Stress Conditions
Regional Horizontal Stress And Its Effect On Longwall Mining
Deformation Development Around Mine Roadways And Simulation
Monitoring Mobile Roof Supports
Analysis Of Retreat Mining Pillar Stability
Planning And Design For Barrier Pillar Recovery Three Case H
Influence Of Partings In A Coal Seam On Long Term Pillar Sta
A Cooperative Study Of Gate Entry Designs Welbeck Colliery (
Comparative Case Study Of Yielding And Critical Coal Pillar
Comparison Of Empirical, Analytical, And Numerical Methods O
Nonlinear Approach For Determining Design Criteria For Yield
In-Situ Coal Strength Determination - Case Studies
The Design And Application Of Propsetter? In Underground Coa
Renewed Interest In Prop Supports As A Replacement For Wood
Improved Intersection Design And Monitoring In The Sydney Co
Drivage System In Retreat Longwall Gateroad
Case Study Of Stability Investigations Related To Shallow Un
Analysis Of Rockbolt Performance At The Waste Isolation Pilo
Continuous Improvement In Cuttable Coal Rib Support In Austr
Floor Failure Induced By Lateral Stress Ahead Of Longwall Su
Towards A Method Of Determining Floor Quality In An Undergro
Chinese And North American High-Extraction Underground Coal
Integration Of CAD-Based Mine Planning And Subsidence Engine
Development Of A Subsidence Database And Determination Of Su
Statistical Regional Calibration Of Subsidence Prediction Mo
Subsidence Monitoring Results, Thick Seam Longwall Mining In
Application Of Mechanical And Groundwater-Flow Models To Pre
The Application Of Underground In-Seam Seismic Methods (UISS
Vertical Stress Redistribution Around A Retreating Longwall
Entry Stability Monitoring & Analysis For Longwall & Continu
A Case Study Of A Deformation Mechanism Around A Two-Entry G
Multiseam Mining On South African Collieries
Design And Planning Of Lower Seam Longwall Gateroads
Optimizing Pillar Design In A Multi-Seam Environment