If you have access to OneMine as part of a member benefit, log in through your member association website for a seamless user experience.
|This paper presents the results of ill situ horizontal stress measurements using a Minifrac system in several northern Appalachian coal mines. The effect of stress magnitude and orientation on longwall gate entry stability was analyzed using a series of three-dimensional finite element analyses. The best headgate stability is achieved if the maximum horizontal stress is aligned with the direction of longwall retreat or if the panel is oriented such that the maximum stress relaxes over the headgate due to the presence of the newly formed gob. The degree of horizontal stress damage to longwall gate entries depends largely on the stress magnitude and roof geology. Accurate assessments of support or design techniques which may mitigate longwall headgate or tailgate instability in areas of thinly laminated roof and high horizontal stresses must account for the in situ horizontal stress state and site specific roof geology. The ability to measure stresses and map geology is thus essential to prevent ground control failures at the longwall headgate.|
Additional chapters/articles from the SME-ICGCM book Proceedings of 14th International Conference on Ground Control in fining
|Truss Systems For Longwall Tailgate Support - Update||Cable Support Systems For Longwall Gate Road Stability||Innovative Tailgate Support For Heavy Ground: 11 Left Longwa||Parameters Affecting Resin-Anchored Cable Bolt Performance:||Roof Support Performance In High Stress Conditions||Regional Horizontal Stress And Its Effect On Longwall Mining||Deformation Development Around Mine Roadways And Simulation||Monitoring Mobile Roof Supports||Analysis Of Retreat Mining Pillar Stability||Planning And Design For Barrier Pillar Recovery Three Case H||Influence Of Partings In A Coal Seam On Long Term Pillar Sta||A Cooperative Study Of Gate Entry Designs Welbeck Colliery (||Comparative Case Study Of Yielding And Critical Coal Pillar||Comparison Of Empirical, Analytical, And Numerical Methods O||Nonlinear Approach For Determining Design Criteria For Yield||In-Situ Coal Strength Determination - Case Studies||The Design And Application Of Propsetter? In Underground Coa||Renewed Interest In Prop Supports As A Replacement For Wood||Improved Intersection Design And Monitoring In The Sydney Co||Drivage System In Retreat Longwall Gateroad||Case Study Of Stability Investigations Related To Shallow Un||Analysis Of Rockbolt Performance At The Waste Isolation Pilo||Continuous Improvement In Cuttable Coal Rib Support In Austr||Floor Failure Induced By Lateral Stress Ahead Of Longwall Su||Towards A Method Of Determining Floor Quality In An Undergro||Chinese And North American High-Extraction Underground Coal||Integration Of CAD-Based Mine Planning And Subsidence Engine||Development Of A Subsidence Database And Determination Of Su||Statistical Regional Calibration Of Subsidence Prediction Mo||Subsidence Monitoring Results, Thick Seam Longwall Mining In||Application Of Mechanical And Groundwater-Flow Models To Pre||The Application Of Underground In-Seam Seismic Methods (UISS||Vertical Stress Redistribution Around A Retreating Longwall||Entry Stability Monitoring & Analysis For Longwall & Continu||A Case Study Of A Deformation Mechanism Around A Two-Entry G||Multiseam Mining On South African Collieries||Design And Planning Of Lower Seam Longwall Gateroads||Optimizing Pillar Design In A Multi-Seam Environment|