Correlation Between The Effect Of Confining Pressure On Compressive Strength In Triaxial Tests And The Effect Of Diameter/Height Ratio On Compressive Strength In Unconfined Compression Tests

Vutukuri, Venkata S.
Organization: International Conference on Ground Control in Mining
Pages: 6
Publication Date: Jan 1, 1993
Email to a Friend Abstract
Compressive strength of cylindrical specimens of a model material and sandstone with various diameter/height (d/h) ratios was determined in unconfined compression tests. It was observed that the compressive strength increases with increase in d/h ratio. Triaxial compression tests were also conducted on the specimens of the same materials with a d/h ratio of about 0.47. It was observed that the axial stress at failure increases with increase in confining pressure. A very interesting correlation was found between the effect of d/h ratio on compressive strength in unconfined compression tests and the effect of confining pressure on axial stress at failure in triaxial tests. The relationships between d/h ratio and confining pressure, s3 in MPa are:- For model material - s3 = -0.95 + 1.7957*(d/h) 0.7883. For sandstone - s- (-0.4554 + 0.9888* (d/h) 1.0355. The correlation coefficients for these equations are 0.9997 and 1. These equations are valid for d/h ratios of up to 10.
Full Article Download:
(1267 kb)


Additional chapters/articles from the SME-ICGCM book Proceedings of 12th International Conference on Ground Control in Mining

Bolting Practice In Longwall Gateroads At The Miike Colliery
Cable Supports For Improved Longwall Gateroad Stability
Comparisons Of Active Versus Passive Bolts In A Bedded Mine
Flexibolt Flexible Roof Bolts: A New Concept For Strata Cont
The Design And Application Of Hercules Cribs For Underground
Cyprus Shoshone Tailgate Roof Control: Case Study
Engineering Methods For The Design And Employment Of Wood Cr
The Use Of Foamed Cement Cribs At American Electric Power Fu
A Comparison Of Support Reactions To Retreat Longwall Front
Entry Design For Optimum Stability In A Multi-Seam Environme
Gate Entry Design For Longwalls Using The Coal Mine Roof Rat
A Test Of Predictive Numerical Models To Simulate Entry Desi
The Coal Mine Roof Rating (CMRR) A Practical Rock Mass Class
Comparative Analysis Of Longwall Gateroad Designs In Four De
Further Improvements In The Roof Beam Tilt Method Of Gateroa
Application Of A Static And Geophysical Monitoring System Fo
Flexible Support Design For Gateroads Of Retreating Longwall
Longwall Support Monitoring
Case Studies Using Mine-Wide Monitoring Systems For Geotechn
An Application Of Tree Classification Method In Analysis Of
Image Analysis Development And Application To Fracture Patte
Mathematical Modeling Of Strong Roof Beds In Longwall Mining
Load Deformation Behavior Of Simulated Longwall Gob Material
Monitoring Of The Interaction Effects Over A Longwall Panel
Design, Monitoring And Evaluation Of A Pre-Driven Longwall R
Ground Control And Safety Considerations During Longwall Rec
Utilization Of Polymer Grid Structures In Shield Recovery Op
The Impact Of Variability In Coal Strength On Mine Planning
Underground Application Of Optimization
Modern Geotechnical Exploration And Mine Design
A New Method For Longwall Pillar Design
A Rock Mass Strength Concept For Coal Seams
Techniques To Increase Yield Pillar Residual Strength
Application Of Seismic Tomography For Assessing Yield Pillar
Structure, Strength And Relaxation Of Interbuden For Input I
Rock Compaction Caused By Dewatering In Poorly- Consolidated
Correlation Between The Effect Of Confining Pressure On Comp
Characterization Of Structural Integrity And Stress State Vi
Rock Mechanics Property Data Bank For Coal Measure Strata
Failure Modes Of Mine Tunnels In Stratified Rock Structures
Determination Of Plate Size Effect On Ultimate Bearing Capac
Development And Evaluation Of A Floor-Bearing Capacity Test
Investigation Of Blast Damage And Underground Stability
Development Of A Slope Stability Program For Improved Quarry
Material Instability Hazards In Mine Processing Operations
Mine Design Considerations For Surface Subsidence Control
Surface Fracture Development From Mine Subsidence In Eastern
An Integrated Approach To Subsidence Modelling And Predictio
Effect Of High-Extraction Coal Mining On Surface And Ground
Economic Evaluation Of Subsidence Damage Mitigation Techniqu