If you have access to OneMine as part of a member benefit, log in through your member association website for a seamless user experience.
|The U.S. Bureau of Mines implemented an inte¬grated static and geophysical monitoring program in a southern Wyoming mine to study changes in seismic wave propagation properties in roof strata. The purpose was to develop techniques to assess roof stability problems. The work consisted of record¬ing deformation and stress histories and calcu¬lating seismic velocity profiles. In addition. geology and roof conditions were mapped; the in¬struments were initially installed at the develop¬ment face; monitoring continued until the mecha¬nized retreat face retreated within 60 m of the instruments. Mining geometry consisted of a three-¬entry gate system using 5.2-m-wide pillars at depths of 426 m. Results were analyzed using stan¬dard history plots, velocity tomographs, and numer¬ical modeling techniques. Changes in velocity. frequency, amplitude, dynamic elastic modulus, and dynamic Poisson's ratio were related to roof defor¬mation, fracturing, and support requirements. A reduction in seismic velocity of 17 pct occurred after 60 mm of roof deformation following installa¬tion of supplementary support. Static measurements revealed significant dilation in the mine floor, spreading to the pillar and the mine roof. Failure was initiated in the floor as a result of uniform pillar penetration.|
Additional chapters/articles from the SME-ICGCM book Proceedings of 12th International Conference on Ground Control in Mining
|Bolting Practice In Longwall Gateroads At The Miike Colliery||Cable Supports For Improved Longwall Gateroad Stability||Comparisons Of Active Versus Passive Bolts In A Bedded Mine||Flexibolt Flexible Roof Bolts: A New Concept For Strata Cont||The Design And Application Of Hercules Cribs For Underground||Cyprus Shoshone Tailgate Roof Control: Case Study||Engineering Methods For The Design And Employment Of Wood Cr||The Use Of Foamed Cement Cribs At American Electric Power Fu||A Comparison Of Support Reactions To Retreat Longwall Front||Entry Design For Optimum Stability In A Multi-Seam Environme||Gate Entry Design For Longwalls Using The Coal Mine Roof Rat||A Test Of Predictive Numerical Models To Simulate Entry Desi||The Coal Mine Roof Rating (CMRR) A Practical Rock Mass Class||Comparative Analysis Of Longwall Gateroad Designs In Four De||Further Improvements In The Roof Beam Tilt Method Of Gateroa||Application Of A Static And Geophysical Monitoring System Fo||Flexible Support Design For Gateroads Of Retreating Longwall||Longwall Support Monitoring||Case Studies Using Mine-Wide Monitoring Systems For Geotechn||An Application Of Tree Classification Method In Analysis Of||Image Analysis Development And Application To Fracture Patte||Mathematical Modeling Of Strong Roof Beds In Longwall Mining||Load Deformation Behavior Of Simulated Longwall Gob Material||Monitoring Of The Interaction Effects Over A Longwall Panel||Design, Monitoring And Evaluation Of A Pre-Driven Longwall R||Ground Control And Safety Considerations During Longwall Rec||Utilization Of Polymer Grid Structures In Shield Recovery Op||The Impact Of Variability In Coal Strength On Mine Planning||Underground Application Of Optimization||Modern Geotechnical Exploration And Mine Design||A New Method For Longwall Pillar Design||A Rock Mass Strength Concept For Coal Seams||Techniques To Increase Yield Pillar Residual Strength||Application Of Seismic Tomography For Assessing Yield Pillar||Structure, Strength And Relaxation Of Interbuden For Input I||Rock Compaction Caused By Dewatering In Poorly- Consolidated||Correlation Between The Effect Of Confining Pressure On Comp||Characterization Of Structural Integrity And Stress State Vi||Rock Mechanics Property Data Bank For Coal Measure Strata||Failure Modes Of Mine Tunnels In Stratified Rock Structures||Determination Of Plate Size Effect On Ultimate Bearing Capac||Development And Evaluation Of A Floor-Bearing Capacity Test||Investigation Of Blast Damage And Underground Stability||Development Of A Slope Stability Program For Improved Quarry||Material Instability Hazards In Mine Processing Operations||Mine Design Considerations For Surface Subsidence Control||Surface Fracture Development From Mine Subsidence In Eastern||An Integrated Approach To Subsidence Modelling And Predictio||Effect Of High-Extraction Coal Mining On Surface And Ground||Economic Evaluation Of Subsidence Damage Mitigation Techniqu|