If you have access to OneMine as part of a member benefit, log in through your member association website for a seamless user experience.
|An example application is presented in which Time Domain Reflectometry (TDR) was utilized to monitor roof strata movements during pillar extraction in a potash mine. The study was initiated when Western Ag-Minerals decided to implement secondary mining of pillars in order to extend the life of their Nash Draw Mine. A prototype operation was conducted in one mine panel to assess mining equipment and procedures, and to determine if ground control problems would develop. An instrumentation array was installed by personnel from New Mexico Tech and Western Ag to monitor strata movements, changes in pillar stress and surface subsidence, and these data are being analyzed by the Bureau of Mines. This paper is limited to a discussion of roof-floor convergence and roof strata movement to illustrate the application of TDR to ground control. Plots are presented which demonstrate the capability of distinguishing location, magnitude and mode of rock movement using TDR to interrogate coaxial cables grouted into holes drilled in the roof.|
Additional chapters/articles from the SME-ICGCM book Tenth International Conference on Ground Control in Mining Proceedings (ICGCM) 10th
|Practical Aspects Of Longwall Pillar Design||Assessment Of Underground Structural Design||Load And Convergence Measurements In Longwall Faces And Desi||A Model Of Shield-Strata Interaction And Its Implications Fo||Stability Of Interpanel-Pillar And Deformation Of Gateroad D||Use Of Polymer Grids For Longwall Shield Recovery||Methods Of Controlling Thick And Strong Roof In Longwall Min||Tensioned Point Anchor Resin System Versus Non-Tensioned Ful||Thrust Bolting: A New Innovation In Coal Mine Roof Support||An Alternative To A Manual Torque Check On Roof Bolts||Shear Bond Stresses Along Cable Bolts||An Underground Trial Of Cable Slings For Remedial Support Of||Mobile Roof Support For Retreat Mining||Application Of Time Domain Reflectometry To Ground Control||An Examination Of Energy Calculations Applied To Coal Bump P||Delineation Of Abandoned Workings With An In-Seam Seismic Me||Remote Detection Of Abandoned Mine Workings Using Radio Imag||Effects Of Surface Topography On The Stability Of Coal Mine||Site Characterization For Ultra-Close Multi-Seam Mining||Mining Under Rivers In Fuxin Coal Mines||Use Of Database In Ground Control To Identify Weightings And||Integrating Ground Control And Mine Site Data Through A Geog||Determination Of The Rock Strength From Portable Rock Tester||Mine-Wide Physical Property Trend Identification Using Porta||Subsidence Prediction In Illinois Coal Basin||Determination Of The Stopline Subsidence Profile Of Phalen 2||Evaluation Of Subsidence Parameters For Inclined Seams In UK||Measurement Of Structural Deformation And Tilt During Subsid||Drag Picks - Influence Of Tool Geometry And Angle Of Arrack||Roof Sounding Device - A Loose Rock Detector||Advanced Surveying Method For Measuring Roof Convergence||Geomechanical Substantiation Of Extraction Of Undermined Ore||Relationship Between Floor Rock Stress And Floor Failure||The Influence Of Geomining Parameters Over Stress Distributi||Finite Element Modeling Of Subsidence Induced By Underground||The Structural Response Of A Steel Lattice Transmission Towe|