If you have access to OneMine as part of a member benefit, log in through your member association website for a seamless user experience.
|This paper describes a joint cooperative project between the CANMET Cape Breton Coal Research Laboratory and the Cape Breton Development Corporation to conduct a trial of split set cable slings for remedial support in longwall gateroads. Slings were installed in two test sections of the 2 West panel, Phalen Mine which exhibited deformation and the potential for excessive deterioration when subjected to the front abutment of the wallface. Roadway support behaviour was monitored at the trial sites, including lengths of roadway with the standard support of steel sets without remedial support. Observations were made on convergence, loading of the steel supports, loading of the slings, and wallface performance. Comparisons are made of the results obtained from the areas with remedial support to that without, which demonstrates that the slings provided effective remedial support limiting further deterioration of the roof. Improved face end conditions have contributed to increases in safety and productivity of the longwall panel.|
Additional chapters/articles from the SME-ICGCM book Tenth International Conference on Ground Control in Mining Proceedings (ICGCM) 10th
|Practical Aspects Of Longwall Pillar Design||Assessment Of Underground Structural Design||Load And Convergence Measurements In Longwall Faces And Desi||A Model Of Shield-Strata Interaction And Its Implications Fo||Stability Of Interpanel-Pillar And Deformation Of Gateroad D||Use Of Polymer Grids For Longwall Shield Recovery||Methods Of Controlling Thick And Strong Roof In Longwall Min||Tensioned Point Anchor Resin System Versus Non-Tensioned Ful||Thrust Bolting: A New Innovation In Coal Mine Roof Support||An Alternative To A Manual Torque Check On Roof Bolts||Shear Bond Stresses Along Cable Bolts||An Underground Trial Of Cable Slings For Remedial Support Of||Mobile Roof Support For Retreat Mining||Application Of Time Domain Reflectometry To Ground Control||An Examination Of Energy Calculations Applied To Coal Bump P||Delineation Of Abandoned Workings With An In-Seam Seismic Me||Remote Detection Of Abandoned Mine Workings Using Radio Imag||Effects Of Surface Topography On The Stability Of Coal Mine||Site Characterization For Ultra-Close Multi-Seam Mining||Mining Under Rivers In Fuxin Coal Mines||Use Of Database In Ground Control To Identify Weightings And||Integrating Ground Control And Mine Site Data Through A Geog||Determination Of The Rock Strength From Portable Rock Tester||Mine-Wide Physical Property Trend Identification Using Porta||Subsidence Prediction In Illinois Coal Basin||Determination Of The Stopline Subsidence Profile Of Phalen 2||Evaluation Of Subsidence Parameters For Inclined Seams In UK||Measurement Of Structural Deformation And Tilt During Subsid||Drag Picks - Influence Of Tool Geometry And Angle Of Arrack||Roof Sounding Device - A Loose Rock Detector||Advanced Surveying Method For Measuring Roof Convergence||Geomechanical Substantiation Of Extraction Of Undermined Ore||Relationship Between Floor Rock Stress And Floor Failure||The Influence Of Geomining Parameters Over Stress Distributi||Finite Element Modeling Of Subsidence Induced By Underground||The Structural Response Of A Steel Lattice Transmission Towe|