If you have access to OneMine as part of a member benefit, log in through your member association website for a seamless user experience.
|A procedure fm the estimation of pilla1 strength is presented where the design of underground coal pillars is emphasized. An analytical approach has been developed, proposing that the effect of end constraints on the pillar strength and the ductile behavior of coal material should be incorporated in the computation of the stability of coal pillars. Bad on this approach, it has been found that end constraint has a significant influence on the pillar strength. The study indicates that when the end constraint is zero the computed strength of the pillar is the same as the unconfiied compressive strength of the coal mass and will not increase with the increase in the width to height ratio. However. when the end constraint is greater than zero the pillar strength will increase exponentially as the width to height ratio increases.|
Additional chapters/articles from the SME-ICGCM book Ninth Conference on Ground Control Mining Proceedings (ICGCM) 9th
|Multiple-Seam Mining - A State-Of-The-Art Review||Design Aspects In Multiple-Seam Mining: Case Studies||Jenmmar Compression Roof Control System||Specialty Truss System And Their Performance||A Case Study Of Grouted Roof Bolt Loading In A Two-Entry Gat||Analysis And Field Testing Of Presupport Application In Coal||Development Of Roof Stitching As A Method Of Support In Indi||Control Of Roadway Closure In Underground Coal Mines By Side||An Application Of Fem Back Analysis Method To Mine Roadway||Controlled Blasting During Drifting In Hard Rock Mine||Field Test Results On Dyna-Rok And Dyna-Rok Plus Anchors||Mine Pillar Stability Analysis Using Fem Methods - Two Case||An Analytical Approach For The Estimation Of Pillar Strength||International Conference On Ground Control In Mining Design||A New Rock Mass Failure Criteria Based On Rate Of Movement||Practical Consideration In Longwall Support Selection||Mine-Wide Monitoring Applications In Ground Control Research||Longwall Stability Analysis Of A Deep, Bump-Prone Western Co||Stability And Control Of Immediate Roof Of Fully Mechanized||An Analysis Of Longwall Shield Cycle Effectiveness By Polyco||The Impact Of Three Longwall Coal Mines On Streamflow In The||Progressive Failure Of The V-Day Mine And A Comparison With||Controlling Subsidence Effects Using Partial Backfilling||Potential Of A Void Diffusion Model To Predict Longwall Subs||The Use Of Rim- To Detect Geologic Anomalies In The Clarion||The Effect Of Hazardous Geologic Structures On Gateroad Stab||Improved Source Location And Evaluation Of Seismic Events Ov||Application Of Short-Term Time-Dependent Plate Loading Tests||Determination Of Classification Parameters For Clay - Bearin||Intrinsic Response Of Borehole Pressure Cells Laboratory Cal||Application Of Sliding Roof Bar Powered Support For Thick-Se||Drainage Of Water From Abandoned Mines By Horizontal Drillin||A Statistical Analysis Of Falls Of Ground In South African C||Three-Dimensional Analysis Of Mine Dump Point Stability||Birth Of A Longwall-Initial Planning To Post-Subsidence Miti||Progressive Hangingwall Caving And Subsidence Prediction At|