Mine Layout Deign for Coal Bump Control

Maleki, Hamid
Organization: International Conference on Ground Control in Mining
Pages: 15
Publication Date: Jan 1, 1987
A comprehensive study consisting of stress determinations, core logging, laboratory testing, and numerical analyses was conducted to investigate the cause and potential alternatives to the coal bump conditions that developed in the Second North Panel of the Little Dove mine near Buntington, Utah. Roof rock characteristics were such that a cave did not develop above this 420 ft wide panel. After 700 ft of pillar retreat, severe coal bump conditions developed during pillar mining. The coal bump conditions resulted from excessive pillar stress which was caused by load transfer from the extracted, noncaving, portion of the panel. Site specific data and numerical modeling techniques were used to back-analyze the bump prone condition. This back- analysis lead to the identification of critical stress, closure, and energy release levels. These critical levels were then used to evaluate alternative pillar mining sequences in the hope that the potential for coal bumps could be reduced. It was found that while alternative sequences offered some potential improvement over the pillar mining sequence used in the mine, alternative pillar mining sequences would not significantly reduce the potential for bumps. For the roof characteristics at this mine, coal bumps are best avoided by developing narrow panels or significantly wider panels, which incorporate properly sized barrier pillars. Narrow panels, on the order of 300 ft, would not cave, but panel pillar stresses and the potential for umps would be moderated by the reduced r' panel width. Wider panels, of approximately 650 ft, would allow a cave to develop, also reducing panel pillar stresses and coal bump potential.
Full Article Download:
(3237 kb)

Additional chapters/articles from the SME-ICGCM book Proceedings 6th International Conference on Ground Control in Mining (ICGCM) 6th

Microseismic Monitoring of Mountain Bumps and Bounces: A Cas
Factors Influencing the Occurrence of Coal Pillar Bumps at
Longwall Pace Bursts and Inadequate Caving: A Came Study
Mine Layout Deign for Coal Bump Control
The Strong Outbursts of Coal and Gas in Coal Mines in China
Bock Bursts Occurrence. in the Coeur D'Alene Mining Dis
A History of Bock Burst Research in the Coeur D'Alene M
Chemical Destressing to Alleviate Rockbursts
Rockburst Control Measures at INCO's Creighton Mine
Prevention. Control and Management of Coal and Gas Outbursts
Application in Design for Close Proximity Multi-Seem Mining
Geologic Conditions Affecting Mineability in the Jane Mine.
Analysis of Cutter Roof Using the Boundary Element Method
A Novel Ground Control Program at Plateau Mining Company
Evaluation of Anchorage Integrity for Grouted Bolts in Weak
STRATA III ? A Full-Spectrum Roof Control Concept
Study of Ground Movement Over a Longwall Mine
Field Measurements of Overburden and Chain Pillar Response t
A Method for Sizing Longwall Pillars Based on Field Measurem
Aspects of Chain Pillar Design in Relation to Longwall Minin
The Initial Collapse of the Overburden Over Longwall Panels
Monitoring and Prediction of Ground Movements Above Undergro
Mechanisms of Chimney Subsidence Over Abandoned Coal Mines
Time-dependent Behavior of Immediate Weak Floor Strata from
The Significance of Specimen Stiffness and Post Yield Charac
Frictional Properties of Rock Applied to Mining Excavations
Ice Pillars, Packwalls, and Brattices
Investigation of Subsidence Over AML: A Case Study
Deign of Support System for Mining Tunnels in Carboniferous
Support of Tunnels in South African Gold Mines
The Stress Measurement and Underground Engineering
Field Measurements Of Overburden And Chain Pillar Response T