Reinforcement of Large Pillars by Bolting

Mitchell, S. J.
Organization: International Conference on Ground Control in Mining
Pages: 10
Publication Date: Jan 1, 1984
An analysis of bolting reinforcement of several large [approximately 18 m (60 ft) cube] pillars was performed. The many overcoring stress profiles in pillars at the mine were used to produce generalized stress distributions at various stages in pre- and post-failure. A complete stress-deformation curve was estimated from this data. The effect of pillar bolting on the load-deformation behavior was extrapolated from the observed unbolted behavior. Bolting can increase pillar strength by up to 10 percent. The effect of bolting on general mine stability was examined with a shoW computer analysis. The computer model was calibrated against measurements performed at the mine, and produced good agreement between measured and modeled stresses. The analysis indicated that bolting increases the bolted pillar safety factors in the event of additional pillar failure by a small amount (approximately 5 percent). Progressive pillar failure is unlikely, because arching transfers most load from yielding pillars to large unmined abutments rather than to the smaller panel pillars.
Full Article Download:
(1470 kb)

Additional chapters/articles from the SME-ICGCM book Rock Mechanics in Productivity and Protection ? Proceedings Twenty five Symposium on Rock Mechanics

Mining-Induced Stress Measurement With Hydraulic Borerole Pr
Instrumentation and Monitoring For Pillar Extraction in a De
Reinforcement of Large Pillars by Bolting
Pressure Measurements in the Gob
Determination Of Solution Cavern Spacing In Deep Salt Deposi
Leached Salt Cavern Design Using a Fracture Criterion for Ro
Numerical Modeling Of "Stiff" Backfill in the Coeur D'A
Stress Control Method Applied to Stabilization of Undergroun
Optimun Mining Plan for Multiple Seam Mining
An Investigation of the Causes of Cutter Roof Failure in a C
Methods of Designing Mechanical Roof Bolting in Horizontally
Rock Bursts In Human Collieries
Constraint - The Missing Variable in the Coal Burst Problem
Prediction of Inter-Strata Movements Above Longwall Faces
Controlled Load Development At Longwall Coalfaces
Technique To Measure Resultant Load Vector On Shield Support
An Improved Technique of In-Situ Measurement Of Fracture Zo
Comprehensive Observation And Research On The Mechanism Of W
Displacement Discontinuity Method For Three-Dimensional Stre
Recent Developments In Subsidence Prediction And Control For
A Method For Assessing The Potential Of Mine Subsidence At A
Ground Movements Associated With Pillar Extraction Coal Mini
Application Of Time Domain Reflectometry To Mining
Proposed Criteria For Subsidence Damage To Buildings
Stability of Slopes in Discontinuously Jointed Rock
A Case History of the Effect of Mine Subsidence on a Concret
Microcomputer Simulation of Rock Blasting to Predict Fragmen
Probabilistic Analysis of Blasting Impact on Open Pit Stabil