Support Selection For The Multi-Lift Mining Method

Goode, Claude A.
Organization: International Conference on Ground Control in Mining
Pages: 15
Publication Date: Jan 1, 1981
Large quantities of high grade coal exist in thick seams in the United States. Many of these thick seams are too deep to be surface mined and do not lend themselves readily to underground extraction. To develop the new mining technology required to effectively mine thick seams, the Department of Energy has entered into a Cooperative Agreement with Mid- Continent Resources, Inc. to demonstrate the multilift longwall mining technique in a 28 foot-thick seam at their L.S. Wood No. 3 mine near Redatone, Colorado. The seam will be extracted in two lifts, with a 5-foot natural partition of coal left between the upper and lower lifts. Proper selection of face supports is critical to the success of this project. Specifications were defined for the roof supports, and it was concluded that the supports selected must provide full coverage, yield at the legs, and have a 60-inch push- out cantilever that can be set at any position under full load. A Hemscheidt two-leg shield was judged as the best qualified candidate and was selected for the multi-lift trial.
Full Article Download:
(4574 kb)


Additional chapters/articles from the SME-ICGCM book Proceedings Of The 1st Annual Conference On Ground Control In Mining

Stress And Stability In Coal Ribsides And Pillars
Improved Design Of Coal Pillars For U.S. Mining Conditions
Review Of Pillar Design Equations Including The Effects Of C
Abutment Pillar "Notching" Improves Abutment Tunnel Roof Con
The Influence Of Certain Geologic And Geotechnical Factors O
Considerations Of Gas Outbursts In Using Dome Salt Mines For
An Overview Of Bureau Of Mines Ground Control Research
Stability Behaviour Of Coal Mining Tunnels With Different Su
Strata Disturbance Prediction For Mining Beneath Surface Wat
Monitoring For The Evaluation Of The Stability Of Undergroun
Controlled Thrust And Torque Placement Of Mechanical Anchor
Roklok Polyurethane Binder: A Chemical Injection System For
Resupporting High Roof Falls
A New Combination Friction-Suspension Support System Scott
Inorganic Cement Grouted Bolt System
Development Of A Resin Point Anchor
An Engineering Analysis Of "Squeeze" Failure Of Pillars In T
Ground Control In Multiple Seam Mining
Applications Of Reflection Seismics To Mapping Coal Seam Str
The Use Of Geologic Modeling In The Prediction Of Adverse Ro
Design Of Shield Supports For The U.S. Coal Mining Industry
Longwall Mining Of Thin Seams
Support Selection For The Multi-Lift Mining Method
Design And Operation Of Powered And Entry Supports
Evaluation Of Existing Predictive Methods For Mine Subsidenc
A Study Of Longwall Subsidence In The Appalachian Coal Regio
Subsidence Studies In Thick And Steep Coal Seam Mining